Vevor H-007 handleiding
Handleiding
Je bekijkt pagina 7 van 112
- 5 -
● Do not respect the adjustment and special configuration of the machine.
Directions:
This product design is used to perform the following operations in the body
shop:
● Welding φ2.0mm and φ2.5mm
● Welding round meson, OT meson and wavy wire
● Pulling nail,round meson, OT meson and wavy wire
Safety Standards and General Consideration:
General：
1. Before removing the body of the product, pull out the wire first.
2. The operator must be qualified accordingly.
3. The operation can only be controlled by qualified technicians.
4.
Operators are responsible for complying with automotive manufacturers'
protection of electrical and electronic procedures (on-board computers,
on-board radios, alarms, airbags, etc.)
5.
The compressed air power must be cut off and turned off before the
maintenance operation is carried out.
6. Electrodes, electrode arms and other secondary conductors can reach
very high temperatures and stay high for a long time after stopping the
machine. Pay attention to scald.
7.
Preventive maintenance is necessary on a regular basis.
Power Connection
：
1. Check that the device must be connected to the ground coupler and to
the ground.It is in good condition.
2. Check if the workbench is connected to the ground connector. 3.Ensure
that the operator does not have any contact, protection or wet clothing
with the metal parts to be welded.
4. Avoid contact with welded parts.
5. Do not spot weld in very wet places or on wet floors.
Bekijk gratis de handleiding van Vevor H-007, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | H-007 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 20952 MB |
