Vevor D1000 handleiding
Handleiding
Je bekijkt pagina 20 van 256
Pipeline dredging
Pull 6-12 inches of wire cables from the drum with a gloved hand and deliver them
into the pipe, keeping one hand operating the wire. If the speed of the cable is slow
or deformed, then the cable encountered elbow, bend or blockage, should
immediately stop down, analyze the situation encountered, choose effective skills,
and then continue to dredge the pipeline, can effectively improve the dredging
efficiency.
Pay attention to the cable into the pipe, cable into the larger pipe, there will be
cable turned run out of the pipe, cable conversion into the size smaller pipe, or
pipe serious blockage, easy to cause cable winding knot, dredge such pipe, to pay
close attention to the change of the cable, once found abnormal spring to stop in
time, avoid the resulting spring winding knot and scrap, operator hurt.
Unblock the blockage
If the unblocking head extends into the blockage and cannot rotate, the steel cable
will twist and become increasingly severe due to the machine still running. This
requires the steel cable to be pulled back to release the stress on the cable,
causing the unblocking head to come out. Never stop the unblocking head from
rotating and still operate the machine to twist the steel cable.
If the blockage is cleared, retract the unblocking head and let it rotate inside the
blockage to continuously break it apart until the unblocking head can bend and
rotate freely.
The blockage has been cleared, and the steel cable and dredging head may be
filled with dirt, affecting normal operation. This requires returning the steel cable to
clean up these garbage (see the section on recycling steel cables).
Handle the dredge head in the blockage.
If the head is stuck in the blockage and cannot exit, the manual cable should
immediately release the foot switch, grasp the cable after the machine stops,
otherwise the cable will knot, twist and break; for the automatic cable, loosen the
foot switch, place the automatic device handle with the plum screw at the angle,
and hold the wire, otherwise the motor will rotate to release the stress, until the
stress of the cable is released, and then release the hands. Place the switch CW /
OFF / CCW in the OFF position.
Bekijk gratis de handleiding van Vevor D1000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | D1000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 37740 MB |
