Vevor AP-0 handleiding
Handleiding
Je bekijkt pagina 7 van 72
- 6 -
OPERATION
Arbor Press Features
The arbor press (see Exploded view on page 8) consists of a cast iron base, an
anvil, a pressing handle with a lock knob, and a rack-type ram.
The removable anvil has four cutouts that can be used for pressing off or pressing
on bearings or bushings of various sizes.
Set-up and Operation
Note: The item numbers provided in the procedures that follow correspond with the
item numbers in the exploded view in the replacement Parts section; see page 8.
Do not use the arbor press without first securing the arbor press to the workbench
and anchoring the workbench to the floor.
Mount the arbor press to the workbench or stand and secure it with bolts using the
holes in the base (1). Also, secure the workbench or stand on the floor.
Changing Ram Position
The ram has a flat surface on one end and a hole on the other end. The hole is
used to accept the punch inserts. Change out the ram as follows:
A. Remove the handle by loosening the knob (17). Then remove one cap (5) from
the handle assembly. Remove the handle (6) from the pinion (16).
B. Remove the pinion retainer (14) by backing off the Set Screw (13). Now slide
the pinion retainer (14) off of the pinion (16).
C. Pull up the ram (4) enough to provide slack to remove the pinion (16) from the
arbor press.
D. Pull the ram (4) out the top of the arbor press body. Turn the ram (4)
end-for-end.
Hint: If the ram does not freely come out of the arbor press body, loosen the two
hex nuts (11) on the side of the arbor press body and the two hex nuts (11) on the
front plate (12).
Bekijk gratis de handleiding van Vevor AP-0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | AP-0 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8893 MB |
