Vevor 3 IN 1/305 handleiding
Handleiding
Je bekijkt pagina 19 van 207
- 17 -
Trouble
Probable Cause
Remedy
SHEAR
Material won’t cut.
Incorrect blade gap.
Adjust gap to accommodate
thicker material.
Machine capacity exceeded.
Use materials within capacity.
Cuts not square.
Unequal blade gap.
Make blade gap equal.
Not contacting table guides.
Maintain consistent guides
contact.
Blade is bowed.
Remove bow.
Insufficient hold-down
pressure.
Adjust hold down.
Poor cut quality.
Dull blade(s).
Replace or sharpen.
Incorrect blade gap.
Adjust gap as needed.
Loose gibes.
Adjust backlash out of gibes.
BRAKE
Workpiece not
bending, or
bending difficult.
Workpiece too thick.
Use materials within capacity.
Improper bend allowance.
Adjust brake beam for proper
bend size.
Bend radius not
consistent across
material.
Machine capacity exceeded.
Use materials within capacity.
Brake beam improperly set for
bending
allowance.
Adjust brake beam for
consistent bend.
SLIP ROLL
Cones are made
when trying to roll
cylinders.
Rolls not parallel.
Adjust idle (rear) roll until
parallel to upper press roll.
Workpiece not
bending.
Machine capacity exceeded.
Use materials within capacity.
Idle roll not engaging.
Inspect and make corrections as
needed.
Bekijk gratis de handleiding van Vevor 3 IN 1/305, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | 3 IN 1/305 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 24980 MB |
