Vestil WL-100-5-68 handleiding
Handleiding
Je bekijkt pagina 4 van 16
6/25/2015 Manual, WL-100.doc
ROUTINE MAINTENANCE & SAFETY CHECKS – WL-100
o Warning: Care should be taken to identify all potential hazards and comply with applicable safety procedures
before b
eginn
ing work.
o Warning: Rai
se the platform and install the maintenance props before beginning any inspections or work on the
unit.
o Only qualified individuals trained t
o understand mechanical devices and their associated electrical an
d hydraulic
circuit
s should attempt troubleshooting and repair of this equipm
ent
(A) Before each
use inspect for the following:
1.) Frayed wires
2.) Oil leaks
3.) Pinched or chafed hoses
4.) Damage or structural deformation to the structural members, the cylinder brackets, etc.
5.) Unusual noise or binding, or evidence thereof.
6.) Proper functioning of all limit switches, including those on the perimeter pinch point guard.
(B) Inspect monthly for:
1.) The oil level. Oil should be 1½” to 2” below the reservoir’s fill hole with the lift fully lowered.
See below for the hydraulic oil specification.
2.) Worn or damaged hydraulic hoses and electrical wires.
3.) Pivot point wear.
4.) Rollers’ looseness and wear.
5.) Integrity of the retaining rings on all rollers and on all pivot point pins.
6.) The integrity of the frame anchor bolts, and for cracks in the concrete around them.
7.) Proper functioning of any hand- or foot-operated mechanisms.
8.) Damage or deformity of the bridge plates (including the hinge) and the handrails.
9.) Unusual noises or movement during operation.
10.) All the information, safety, and warning labels being in place and in good condition.
11.) The need to clean off dirt and debris.
12.) Grease all pivot points.
(C) Yearly inspection
The oil should be changed if the oil darkens, becomes gritty, or turns a milky color (indicating the presence of
water). Replace with an anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F, (ISO 32 at 40°C). Ex: AW
32 or HO 150 hydraulic oil, or a non-synthetic transmission fluid. You may use a synthetic transmission fluid if you flush
the system with the synthetic fluid before filling the reservoir.
VESTIL MFG. CO./T&S EQPT. CO. 4 of 16
Bekijk gratis de handleiding van Vestil WL-100-5-68, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | WL-100-5-68 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2869 MB |
