Vestil WL-100-10-812 handleiding
Handleiding
Je bekijkt pagina 24 van 30
Operator’s Manual Rev. 6/11/25 WL-100 MANUAL 06-25.DOCX
Table of Contents Copyright 2023, Vestil Manufacturing Corp. Page 24 of 30
Cross-traffic loads up to twice the Lift’s capacity are allowed with the platform fully lowered. Do not exceed a travel
speed of two feet per second when moving loads across the platform. Do not actuate the Lift while a load is in motion
on the platform.
DO NOT exceed the lift table’s load ratings. Injury to personnel or permanent damage to the lift
table can result from exceeding the listed capacity. Take into account the weight of any equipment
added to the platform by the user or third parties when determining the maximum working load to
be placed on the platform.
The platform rollers are not captured. DO NOT overhang any load over the side of the platform. A
cantilevered or overhanging load at the hinged end can cause the platform to tilt and dump the
load. For applications involving side or end edge loading, consult the factory.
Operating the lift.
The Dock Lift is furnished with an external electric-hydraulic power unit and a handheld pushbutton control.
Place the safety chains across the openings on both ends of the Lift.
Make sure both bridge segments are raised.
Press the “RAISE” pushbutton to energize the pump motor and raise the
platform to the level of the truck. The platform will rise only while the
pushbutton is pressed. When the pushbutton is released, the platform will
stop and hold its position. The upper travel limit switch prevents upward
travel beyond the platform’s maximum height.
Use the handles to lower the bridge segments onto the truck’s deck. If
necessary, adjust the platform height to match that of the truck.
Remove the safety chain between the platform and the truck. Load/
unload the truck.
When ready to lower the platform, place the safety chain back over the
truck-side opening. Use the handles to lift both bridge segments.
Press the “LOWER” pushbutton to open the hydraulic valve and lower the platform. Take care to prevent the
cord from becoming pinched in the legset mechanism. The platform descends by gravity, and the pump motor
will not run. Release the pushbutton to stop the motion of the platform. If the perimeter toe guard encounters
an object, the valve will close and will prevent further descent of the platform.
The WL-100 Lift is provided with hydraulic overload protection that will prevent it from raising a load in excess
of its rated capacity. Its lowering speed is preset at the factory, and will not exceed a speed of 30 fpm. In the
event of a hydraulic line failure, a velocity fuse internal to the cylinder will prevent the platform from lowering.
In the event of a power failure, the Lift may be manually lowered. Follow the procedure for manually lowering
the lift, p. 20.
Always watch the area around the platform and any load on the platform when it is in operation.
Never use the Dock Lift if any damage or unusual noise is observed, if it is in need of repair, or if any
other malfunction is observed. Notify your supervisor or maintenance personnel.
Keep all personnel clear of the Lift when it is in operation. Before operating the Lift, make certain no
part of any person or object is under the platform.
All guards shall be in place before operating the Lift.
Guards cannot protect against every possible condition, and should not be considered a substitute
for good judgment and care in use, loading, handling, storage, etc. of the Dock Lift.
Bekijk gratis de handleiding van Vestil WL-100-10-812, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | WL-100-10-812 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8817 MB |
