Vestil WL-100-10-68 handleiding
Handleiding
Je bekijkt pagina 22 van 30
Operator’s Manual Rev. 6/11/25 WL-100 MANUAL 06-25.DOCX
Table of Contents Copyright 2023, Vestil Manufacturing Corp. Page 22 of 30
26. Operate the lift table through several full raise and lower cycles. Verify that actuating the upper travel limit
switch (mounted on the base frame) prevents further upward travel of the platform. Verify that actuating the
perimeter toe guard switches (under the platform) from any side of the lift table prevents further downward
travel of the platform. DO NOT place a lift table in service if either of these devices isn’t functioning properly.
27. Check the hydraulic oil level. It should be filled to within 3” (75 mm) of the top of the reservoir. If oil is needed,
use an anti-wear hydraulic oil with a viscosity grade of 150 SUS at 100°F (ISO 32 at 40°C) or a non-synthetic
automatic transmission fluid.
28. Clean up any debris or spilled oil. Verify that all of the information, safety, and warning labels are in good
condition.
29. If installing the optional approach ramp, put it in position, leaving a gap of ¼”-1” (6 mm – 25 mm) between it
and the Lift platform. Anchor the ramp to the floor.
RECORD OF SATISFACTORY CONDITION
After assembling and installing the Dock Lift, and before using it for the first time, make a record describing its
appearance. Thoroughly photograph the Lift from multiple angles, including all welds and anchor points, and all labeling
applied to it. Describe where each label is located. Collect all photographs and writings into a file. Mark the file
appropriately to identify it. This record documents satisfactory condition. Compare the results of future inspections to
this record to determine if the Lift is in satisfactory condition. Do not use the Lift unless it is in satisfactory condition.
Purely cosmetic changes, like damaged paint or powder coat, do not constitute changes from satisfactory condition.
However, touchup paint should be applied to all affected areas as soon as damage occurs.
OPERATION INSTRUCTIONS
Consult ANSI standard MH29.1 (Industrial Scissor Lifts), Section 12 for the owner’s/user’s responsibilities regarding
the operation, care, and maintenance of this Dock Lift.
The user shall ensure that operators understand that safe operation of the Lift is the operator’s responsibility. The
user shall also ensure that operators are knowledgeable of, and observe, the safety rules and practices in this section.
The Premium Truck Scissor Dock Lift is suitable for indoors and outdoors use in most non-classified industrial
locations and many commercial locations. It is intended to lift freight and material handling equipment, such as pallet
jacks and fork trucks, for loading and unloading box trucks and semi trailers.
This Dock Lift is not intended, and DOES NOT meet ANSI standards, for service as: a lift platform for
passengers; a vertical lift for mobility impaired persons; an elevated work platform, or; a vehicle
service lift. DO NOT use the Lift for purposes other than lifting or lowering freight and equipment to
and from a truck.
Bekijk gratis de handleiding van Vestil WL-100-10-68, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | WL-100-10-68 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8817 MB |
