Vestil VAN-J-DC handleiding
Handleiding
Je bekijkt pagina 7 van 11
Rev. 2/26/2018 VAN-J, MANUAL
Copyright 2017 Vestil Manufacturing Corp. Page 7 of 11
Using the crane:
To properly operate the crane, apply the following steps.
1. Connect the power cord to the power supply.
a. AC units: connect to a properly grounded, GFCI-protected, 115V outlet.
b. DC units: make sure battery connections are secure.
2. Apply appropriate rigging to the load.
3. Adjust the length and angle of the boom as your application requires. Consult the appropriate table on page 2 to
make sure that the load does not exceed the capacity of the crane in its present configuration.
4. If your crane has a manual winch, stand on the same side of the crane as the winch handle. Turn the handle
clockwise to lower the hook. If your winch is equipped with a powered winch, then it is electronically controlled.
Both AC and DC-powered winches utilize a constant pressure (“dead man”) pushbutton controller. Press the
DOWN button on the handheld controller. The winch will operate only while a control button is pressed. Releasing
the button causes the winch to stop and the hook will maintain its position.
Lower the hook sufficiently to attach the load rigging to it. The load center should be directly below the hook to
prevent significant load swing as it rises. Proper and improper positioning is diagrammed below:
Improperly positioned loads
5. Tighten the knob tightly against the mast.
6. Turn the winch handle counterclockwise or press the UP button to raise the load. Loosen the knob and slowly
rotate the boom. Position the load as desired; then lower it until it is entirely supported by the vehicle.
NOTE: Powered winches are designed for intermittent use. Extended use without pause to allow the motor to
cool will damage the motor. Maximum continuous run time is 3 minutes.
7. Put the crane into storage configuration:
a. Fold the boom against itself.
b. Strap the boom sections together.
c. [AC and DC units] Unplug the winch power cord and store it inside the vehicle whenever the jib is not in use.
Side view
Front view
Hook/cable aligned
with centerline of load
(red dashed line)
Hook/cable not aligned
with centerline of load
(red dashed lines)
Side view
Front view
1
Bekijk gratis de handleiding van Vestil VAN-J-DC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | VAN-J-DC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2080 MB |
