Vestil SST-45 handleiding
Handleiding
Je bekijkt pagina 4 van 8
Rev. 12/20/2016 SST-45, MANUAL.doc
Copyright 2015 Vestil Manufacturing Co. Page 4 of 8
Assembling Instructions:
Step 3: Lift the tabletop latches and lift the tabletop as high as it will go. Then, install the clevis pin into one of the 2 pin holes in
the roller channel as shown below. The clevis pin prevents the scissor legs from moving. After installing the pin, slowly lower the
table until the roller firmly rests against the clevis pin.
The table is easily assembled and disassembled. However, heavy lifting is required and it is, therefore, strongly
recommended that at least 2 people work together to assemble and disassemble the table. [NOTE: Numbers in
parentheses () in steps 1-8 below correspond to item numbers.]
The unit is shipped as shown below. The tabletop must
be deployed and the appropriate spring combination must be installed before it can be used.
Step 1: Remove the (yellow) carousel from the tabletop. Then, remove the
linchpin and clevis pin to release one end of the shock absorber from the shock
bracket as shown below.
Shock abs
orber
Linch
pin
Clevis pin
Clevis
pin
Roller
pin
Linchpin
Roller
rests
against
clevis
pin
Roller
Clevis
pin
Lift latches while raising tabletop
Step 2: Remove the tabletop plug from the
opening above the spring receiver. Turn
the plug and lift it out the top of the table.
Carousel
Tabletop latch
Fork pocket
Shock absorber
Clevis pin + linchpin
Tabletop plug
Spring receiver
Bekijk gratis de handleiding van Vestil SST-45, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | SST-45 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5101 MB |
