Vestil SLNM-118-AA handleiding
Handleiding
Je bekijkt pagina 6 van 14
SLNM, Manual
Copyright 2015 Vestil Manufacturing Corp.
Page 6 of 14
USE INSTRUCTIONS:
1.
Determine Condition of Floor or Other Supporting Surface: Inspect the floor or other surfaces prior to use.
The supporting surface must be smooth and dry so choose a route that avoids obstacles, spills, and surface
damage.
Casters might become stuck in gaps or cracks in the surface, which could cause the SLNM to
stop suddenly. A sudden stop can cause the load to shift and the load and truck might tip over.
2. Inspect the SLNM & Perform a Functions Test:
Inspection Prior to Use:
ALWAYS inspect the unit before you use it.
Begin the inspection by removing all debris found on the surface of
the forks and the housing, and then:
a. Check the forks for deformation and cracks;
b.
Check the floor beneath the truck and the truck itself for leaked hydraulic fluid or battery acid.
DO NOT use the Stacker if you discover any damage or abnormalities. Tag the unit “Out-of-
Service” and report the problem[s] to authorized maintenance personnel.
Functions Test:
Verify that the unit works properly. Drive the stacker to a location where the following tests can be performed
without contacting overhead obstructions or items on the ground:
1. Raise the forks to the maximum elevation;
2. Return the forks to the lowest position.
3.
Raise the forks, and while raising them, press the E-stop button. The forks should immediately stop
moving. Reset the E-stop.
4.
Only use the stacker if all mechanisms function normally. If [a] malfunctions occurred, park the
stacker in a safe location, tag it “Out-of-Service” and then report the malfunctions to maintenance personnel.
Operation:
Step 1: Turn on the power. Pull the red E-stop button up.
Step 2: Press the raise button (green) to raise the forks.
Step 3: Press the down button (red) lower the forks.
Fully raise the forks, and while lowering the forks press the E-s
top.
The
forks sh
ould
immediately stop
moving.
Reset the E-stop.
Step 4: Release the brake by pressing the lever to right of wheel axle.
Step 5: Activate the brak
e by pressing the lever to left of wheel axle.
Step 6: To move the stacker to the desired location and to steer the
unit, pull/push the handles.
Bekijk gratis de handleiding van Vestil SLNM-118-AA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | SLNM-118-AA |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 3423 MB |
