Vestil RT-S-62-AF handleiding
Handleiding
Je bekijkt pagina 7 van 18
RT-S-62-AF, Manual
Copyright 2021 Vestil Manufacturing Corp.
Page 7 of 18
USE INSTRUCTIONS:
1.
Determine Condition of Floor or Other Supporting Surface: Inspect the floor or other surfaces prior to use.
The supporting surface must be smooth, roug and dry so choose a route that avoids obstacles, spills, and
surface damage.
Wheels might become stuck in big gaps, which could cause the RT-S to stop suddenly. A
sudden stop can cause the load to shift and the load and truck might tip over.
2. Inspect the RT-S & Perform a Functions Test:
Inspection Prior to Use:
ALWAYS inspect the unit before you use it.
Begin the inspection by removing all debris found on the surface of
the forks and the housing, and then:
a. Check the forks for deformation and cracks;
b.
Check the floor beneath the truck and the truck itself for leaked hydraulic fluid or battery acid.
DO NOT use the RT-S if you discover any damage or abnormalities. Tag the unit
“Out-of-Service” and report the problem[s] to authorized maintenance personnel.
Functions Test:
Verify that the unit works properly. Drive the RT to a location where the following tests can be performed
without contacting overhead obstructions or items on the ground:
1. Raise the forks to the maximum elevation;
2. Return the forks to the lowest position.
3.
Raise the forks, and while raising them, press the E-stop button. The forks should immediately stop
moving. Reset the E-stop by returning the control yoke to either position 1 or 3 (see Operation Step 3
below on this page), and then pull up on the red button.
4. Fully raise the forks, and while lowering the forks press the E-stop. The forks should immediately stop
moving. Reset the E-stop.
5.
Drive the RT-S in reverse at low speed and while driving press the belly switch. The machine should
immediately move in the opposite direction for ~3 seconds and then stop. Reset the control yoke.
6.
Drive theRT-S in both the forward and reverse directions for a few seconds.
7.
Test the horn .
8. Verify that the control yoke automatically returns to the vertical position when released (see Operation
Step 3 on this page).
Only use the pallet truck if all mechanisms function normally. If [a] malfunctions occurred, park
the truck in a safe location, tag it “Out-of-Service” and then report the malfunctions to maintenance personnel.
Operation:
Step 1: Turn on the power.
Step 2
: Pull the red E-Stop button up to disengage the service brake.
Step 3
: Tilt the control yoke to the drive position (#2), which is shown
in the photograph to the right.
NOTE: The RT-S uses magnetic brakes, which engage when
the handle is in or near either of the neutral positions (1 and 3).
The yoke is designed to automatically return to neutral position #1 after
the handle is released; therefore, the brakes will engage automatically
as well.
Step 4: Rotate the movement control wheel in the appropriate direction to move either forward
or in reverse. [See “Movement Controls” text box and the corresponding photo on p. 6]
1 = Neutral
2 = Drive
3 = Neutral
Bekijk gratis de handleiding van Vestil RT-S-62-AF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | RT-S-62-AF |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 3187 MB |
