Vestil LPC-60 handleiding
Handleiding
Je bekijkt pagina 8 van 11
Table of Contents Rev. 6/1/2022 LPC, MANUAL
Table of Contents Copyright 2021 Vestil Manufacturing Page 8 of 11
STEP 7: Make sure that the load is not swinging or rotating. Slowly lower the hoist hook until the load
contacts the ground or work surface. Lower the load sufficiently to create slack in the clamp chain.
DO NOT disconnect the clamp from the sheet until the material has been stabilized. If you cannot
control BOTH the clamp and sheet material without difficulty, ask someone to help you.
STEP 8: Release the load. Rotate the lock lever to the unlocked position. Pull the clamp off of the
sheet; then disconnect the clamp from the hoist hook. NOTE: It might be necessary to wiggle the
clamp to loosen the connection between the gripper and the sheet.
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Record the condition of the plate clamp before putting it into regular service. Thoroughly
photograph the unit. Include close range photos of all labels and tags, the bale, the gripper and pad,
and the lock mechanisms. Measure the length and width of the bale opening. Measure the gripper
teeth. Measure the throat opening in 3 places: 1) The mouth; 2) Where the pad is located; 3) Back/top
of the throat. Record your measurements. Write a description of the overall condition of the clamp. How
much force is required to lock and unlock the clamp. Lock the clamp. Try to manually move the
gripper. There should be definite resistance against movement while the lock is engaged. Collect all
photographs and writings in a single file. Mark the file appropriately to identify it. The file is a record of
the clamp in satisfactory condition. Compare the results of all inspections to this RECORD to determine
whether the unit is in satisfactory condition. If the clamp is not in satisfactory condition, repair it before
returning it to service. Purely cosmetic changes, like damaged paint/powdercoat, do not constitute
changes from satisfactory condition. However, touchup paint should be applied to all affected areas as
soon as cosmetic damage occurs to prevent rusting and corrosion. If left unaddressed, rust/corrosion
will degrade the condition of the clamp and could make it unsafe to use.
Bale leans to the left; hoist hook
supports the bale.
Bekijk gratis de handleiding van Vestil LPC-60, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LPC-60 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4903 MB |
