Vestil LMS-EBT-46-6 handleiding
Handleiding
Je bekijkt pagina 8 van 12
Table of Contents Rev. 9/25/2023 LMS, MANUAL
Table of Contents Copyright 2022 Vestil Manufacturing Co. Page 8 of 12
a. Verify that the load attachment is stable;
b. Raise the load until it is elevated no more than 6-8 inches above the ground (entirely suspended from the
boom).
c. Slowly transport the load to the desired unloading location;
d. Slowly lower the load until it is entirely supported by the ground and there is slack in all rigging.
e. Disconnect the rigging from the hooks;
f. Adjust the fork position until no more than 6-8 inches above the ground;
g. Return the boom to its storage location.
NOTE: Return OBT and OBNT model booms to the fully lowered (horizontal) position by reversing Step 4 on
p. 24 BEFORE backing out of the fork pockets.
Test the stability of the load in the rigging. Raise the forks slowly to minimize load movement. Raise the forks
until the load is entirely suspended from the boom. Watch the load and boom closely for either of the
following issues: 1) Load movement in rigging; or 2) Boom sliding towards tips of forks. If you notice either
issue, immediately lower the forks and adjust the rigging. Retest the stability of the load in the rigging
While transporting a load with the boom, the load should only be 6-8 inches above the ground. Adjust
load height to avoid obstacles along the travel path.
DO NOT exceed approximately 1.5mph (2.4kph) while transporting a load with the boom.
Travel ONLY on smooth, level surfaces. Turn slowly and smoothly.
If the load is unstable while suspended, DO NOT use the boom.
4. Attach the load to the boom by connecting the load to appropriate rigging. Attach the rigging to the
end hook or to both the end hook and the stabilizing hook.
WARNING
Material handling is dangerous. Improper use of this product might result in serious personal injuries.
Confirm that the load weighs less than the maximum rated load of your boom AND that your fork lift is
rated to lift the combined weight of the boom and the load.
Contact the manufacturer of your fork lift BEFORE using the boom. Request that the lift manufacturer
provide:
1. Written approval to use the boom with your lift truck; AND
2. Markings (labels) for the lift truck that:
– Identify your LM-boom; AND
– Provide the approximate net weight of the forklift truck and boom at the maximum fork
elevation with a laterally-centered load. [29 CFR 1910.178(a)(5)].
DO NOT use the boom until the forklift manufacturer provides adjusted maximum rated load tags for
your fork lift.
DO NOT attempt to lift loads weighing more than the rated load of either the boom or lift truck,
whichever is smaller. Maximum rated load information appears in the tables on pages 4 & 6.
Strictly adhere to all rules applied at your worksite regarding forklift operation, fork attachment usage,
and load rigging.
ONLY use rigging having maximum load ratings that exceed the load weight.
DO NOT connect a load to only 1 hook, which will cause the load to rotate during lifting and transport
operations. Loads should connect to both hooks simultaneously.
Bekijk gratis de handleiding van Vestil LMS-EBT-46-6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LMS-EBT-46-6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3193 MB |
