Vestil LMS-EBNT-40-6 handleiding
Handleiding
Je bekijkt pagina 7 van 12
Table of Contents Rev. 9/25/2023 LMS, MANUAL
Table of Contents Copyright 2022 Vestil Manufacturing Co. Page 7 of 12
LOADING AND USING THE BOOM
Review the SAFETY INSTRUCTIONS on p. 2 and the following additional safety instructions.
WARNING
Improper use of this product might result in serious personal injuries.
DO NOT use this boom with rough terrain lift trucks or telehandlers (boom trucks). ONLY use it with high lift
fork trucks utilizing a vertical mast and carriage.
DO NOT mount the hopper on stackers or manually propelled lift trucks.
DO NOT operate the truck carrying this boom on unimproved surfaces. Only operate on concrete or
asphalt surfaces.
1. Drive the forklift forward and insert the tines into the fork pockets. Drive as far forward as possible. Lower
the forks completely. The drawings below demonstrate this step.
2. Securely connect the boom to the carriage of the forklift with the safety chain.
Wrap the safety chain around the fork carriage and fasten the snap hook to the chain/strap. There
should be no slack in the chain/strap. The sole purpose of the safety chain is to prevent the boom from
sliding off of the forks. It is NOT intended or designed to bear the full load rating.
3. [Telescoping models only] Adjust the boom length:
a. Loosen the X-handle locking bolt (“locking bolt”), by turning it counterclockwise.
b. Grasp the adjustment handle at the end of the boom and pull the boom to the desired length.
c. Tighten the locking bolt by turning it clockwise.
Bekijk gratis de handleiding van Vestil LMS-EBNT-40-6, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LMS-EBNT-40-6 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3193 MB |
