Handleiding
Je bekijkt pagina 8 van 13
Table of Contents Rev. 3.19.2020 LAD-TRS MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Co. Page 8 of 13
ASSEMBLY INSTRUCTIONS
Improper or incomplete assembly might result in a ladder that is unsafe to use.
• Visually inspect all ladder components prior to assembly. Look at each part of the ladder immediately after you
receive the package from the shipper. Determine whether damage occurred during shipping. DO NOT assemble or use
the ladder stand if you notice any damage, especially to the step weldment, back leg weldment, base supports, or
handrails. Using a damaged component could lead to ladder collapse and result in serious personal injuries.
• While assembling this ladder, confirm that only locking fasteners are provided, i.e. only locking nuts. Contact
TECHNICAL SERVICE (p. 1) if you find non-locking nuts. Only lock nuts should be used. However, lock nuts can only
safely be used once. Discard the used lock nut and install a new lock nut after unfastening a connection
• DO NOT assemble the ladder by yourself. At least 2 people are needed for assembly.
• Read the entire instruction manual before assembling this ladder.
• DO NOT use the ladder if a wheel is damaged. Damaged wheels might cause the ladder to wobble or tip when used.
The following tools are necessary to assemble the ladder: 2 crescent wrenches (
5
/
16
” and
3
/
8
”); Rubber mallet.
NOTE: Numbers in diagrams and in parentheses () correspond to part numbers in the exploded views on p 4-7.
Step 1: Fasten the back leg tubes (44-014-487) to the back leg weldment with bolts (11062) and lock nuts
(37021). Then, attach the back leg weldment to the stair frame weldment with
5
/
16
in. hardware. Be sure to
orient the back leg weldment as shown below (support tabs should face inwards).
Step 2: Fasten the vertical braces to the brace tabs. Brace tabs are located on the underside of the platform and on
the back leg weldment. Fasten braces to the tabs with
5
/
16
”–18 hardware as shown. First slide a flat washer (33006)
onto a bolt (11055) and insert the bolt through the tab and the bolt hole in the brace. Secure bolts with lock nuts
(37021). Finger-tighten the connections.
11060
Back leg
weldment
Stair frame
weldment
37021
Ladder
assembly
Brace
tab
Brace tab
Vertical
brace
37021
11055
37021
11062
37021
Back leg tube
33006
Brace tab
Cross brace
Bekijk gratis de handleiding van Vestil LAD-TRS-60-2-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-TRS-60-2-P |
| Categorie | Ladder |
| Taal | Nederlands |
| Grootte | 4197 MB |
