Handleiding
Je bekijkt pagina 12 van 13
Table of Contents Rev. 3.19.2020 LAD-TRS MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Co. Page 12 of 13
• Back leg weldment, wheel brackets (caster tilter frames in exploded parts diagrams, pages 4-7) and wheels: Make
sure that the back leg weldment is not bent, twisted, etc. Wheels must not be severely worn otherwise they will not
roll smoothly. Examine the wheel brackets and hardware for damage. Tighten nuts and bolts.
• Frame members (step weldment, back leg weldment, braces, handrails) and all fasteners (bolts, nuts, pins): Inspect
each frame member for damage like excessive wear, bends, and cracks. All frame pieces should be square, rigid,
and free of rust and corrosion. Remove rust with steel wool or a metal bristle brush and apply touch-up paint to the
affected area. Check the areas where frame members are bolted together. Check the areas around bolt holes for
cracks, elongated bolt holes, etc.
• Square caps: Check the caps for cracks and excessive or uneven wear. If a cap requires replacement, install
replacement caps before returning the ladder to service.
Maintenance: In addition to correcting issues discovered during inspections, maintain the ladder by
• Cleaning it with a damp cloth to remove dirt and grime, especially from step surfaces. Let the ladder dry
completely before returning it to service.
• Lubricating
bolts when necessary for the wheels to rotate freely.
• Applying touchup paint wherever the finish is damaged as soon as damage occurs.
LABELING DIAGRAM
Each unit should be labeled as shown in the diagram. Label content and location are subject to change so your
product might not be labeled exactly as shown. Compare the diagram below to your RECORD OF
SATISFACTORY CONDITION. If there are any differences between actual labeling and this diagram, contact
TECHNICAL SERVICE.
Replace all labels that are damaged, missing, or not easily readable (e.g. faded). To order replacement labels
or to inquire whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
or by calling (260) 665-7586 and asking for the Parts Department.
C: Label 287 (on nosing of a step)
B: Label 904 (on
nosing of a step)
A: Label 740 (on nosing of a step or platform)
D: Label 821 (on nosing of a step)
B
C
D
NOTE 1: Label locations might vary from the diagram for ladders with fewer steps. Include label locations in
the RECORD OF SATISFACTORY CONDITION.
NOTE 2: Attach a protected copy of this manual to the ladder to provide access to this manual to all persons who
use the ladder. For example, a copy of the manual can be placed inside a transparent plastic pouch or folder that
is tied to the ladder frame. An appropriate place to tie the folder is the rear frame.
A
Bekijk gratis de handleiding van Vestil LAD-TRS-50-5-G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-TRS-50-5-G |
| Categorie | Ladder |
| Taal | Nederlands |
| Grootte | 4197 MB |
