Handleiding
Je bekijkt pagina 12 van 13
Table of Contents Rev. 12.6.2018 LAD-MM, MANUAL
Table of Contents Copyright 2017 Vestil Manufacturing Co. Page 12 of 13
Record of Normal Condition:
After assembling the ladder and before putting it into use, visually inspect the ladder. Make a written record that
describes the condition and appearance of the steps, handrails, outriggers, wheels, (leg) caps, base supports, back
leg weldment, platform chain, and fasteners (bolts, nuts, etc.). Thoroughly photograph the ladder and each label
applied to it. Add the photographs to the record. This record establishes “normal condition” of the ladder. When
conducting subsequent inspections, compare your observations to the written record to determine whether the ladder
is in normal condition. Do not use the ladder unless it is in normal condition.
Inspections & Maintenance:
Regular inspections — at least once per month inspect the following items. Replace all parts that are damaged
before using the ladder again. DO NOT continue to use the ladder if damage cannot be repaired.
• Handrails, snap hooks, and platform chains: Inspect both handrails. Confirm that they are solidly fastened to
the step weldment. Each handrail should be rigid and undamaged. Examine the platform chain and snap
hooks. Confirm that they are securely fastened to the handrails and are in normal condition.
• Back leg weldment and wheels: Make sure that the back leg weldment is not bent, that the wheels are not
severely worn, that they are vertical (not angled towards or away from the ladder) and roll smoothly. Examine
the wheel brackets and hardware for damage. Tighten nuts and bolts, if necessary.
• Frame members (step weldment, back leg weldment, base supports, handrails) and all fasteners (bolts, nuts,
pins): Inspect each frame member for damage like excessive wear, bends, and cracks. All frame pieces should
be square, rigid, and free of rust and corrosion. Remove rust with steel wool or a metal bristle brush and apply
touch-up paint to the affected area. Check the areas where frame members are bolted together. Check the
areas around bolt holes for cracks, elongated bolt holes, etc.
• Square (rubber) caps: Check the caps for cracks and excessive or uneven wear. Install replacement caps
before returning the ladder to service.
• Outriggers (11 and 12 step models): Examine the outriggers. Both should be securely fastened to the step
weldment. Both outriggers should make solid contact with the ground, i.e. the ladder should not be able to
wobble. Confirm that the caps on the outrigger legs are in satisfactory condition.
Maintenance: in addition to correcting issues discovered during inspections, maintain the ladder as
described below.
• Clean the ladder to remove dirt and grime, especially from step surfaces.
• Lubricate bolts as necessary for the wheels to rotate freely.
• Apply touchup paint wherever the finish is damaged.
Labeling diagram:
Each unit should be labeled as shown in the diagram. However, label content and location are subject to change
so your product might not be labeled exactly as shown. Compare the diagram below to your Record of Normal
Condition. If there are any differences between actual labeling and this diagram, adapt the diagram to reflect actual
labeling. Replace all labels that are damaged, missing, or not easily readable (e.g. faded). To order replacement
labels or to inquire whether your unit is properly labeled, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
or by calling (260) 665-7586 and asking for the Parts Department.
C: Label 287 ( on nosing of a step)
B: Label 729A (on
nosing of a step)
A: Label 740 (on nosing of a step or platform)
D: Label 821 (on nosing of a step)
A
B
C
D
Bekijk gratis de handleiding van Vestil LAD-MM-12-G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-MM-12-G |
| Categorie | Ladder |
| Taal | Nederlands |
| Grootte | 3732 MB |
