Vestil LAD-FM-96-PSO handleiding
Handleiding
Je bekijkt pagina 17 van 21
TABLE OF CONTENTS Rev. 9/30/2021 LAD-FM-PSO, MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Co. Page 17 of 21
Step 14: Install the floor lock assembly (44-537-007). Press the 3-way control button forward and
raise/retract the ladder to the fully retracted position. Set the floor lock assembly on the floor next to
the ladder. Press the release lever down. Move the floor lock assembly to bring the locking peg into
the locking space between the release lever and the lock plate. Mark the floor with the locations of
the anchor bolt holes on the mounting plate. The bolt holes will accept 3/8” anchor bolts of
appropriate length as selected by your building engineer. Drill holes in the locations of the floor
marks and install anchoring hardware following the manufacturer’s instructions.
USING THE MEZZANINE LADDER
Review the SAFETY INSTRUCTIONS on p. 2-3 before using the ladder. Always grasp the handrails and
face the ladder when climbing or descending the steps. Inspect the ladder before each use for
damage, such as unusual wear, deterioration, or corrosion. Tighten loose nuts. If a lock nut has been
partially or completely unfastened, it must be replaced with a new lock nut.
To lower/extend the ladder from the raised/retracted position:
1. Stand beside the ladder at a location where you will avoid contact with it as it lowers but can easily
monitor it. Twist the red button on the handheld controller in the direction of the arrows until the
button pops up. See FIG. 7
on p. 10.
2. Press down on the release lever foot peg (see Step 14 on p. 17) of the floor lock to release the locking
peg (attached near the bottom of the ladder siderail) from the floor lock.
3. Grasp the segment of cable that extends from the hoist to pulley A and pull it toward you until the
limit switch lever lifts off of the limit switch. See Step 13
on p.16. The cable can either be pulled by
hand or by engaging the cable with the formed fingers of the cable grabber and pulling the cable
grabber away from the ladder.
4. Push the 3-way button on the hand control in the DOWN direction. See FIG. 7 on p. 10. Once the
ladder begins to move, gently release the cable.
5. Hold the button down until the ladder is completely lowered/extended.
6. Push the red button on the handheld controller down. The controller can be stored in the round tube
portion of the cable grabber.
To raise/retract the ladder:
1. Stand to the side of the ladder. Avoid contact with the ladder as it retracts.
2. Twist the red button on the handheld controller until it pops up.
3. Press the UP button on the handheld controller. Hold the button until the ladder retracts completely
and the locking peg seats into the floor lock.
4. Press the red button down and set the controller in the cable grabber.
Locking
peg
Release
lever
Lock plate
Release lever
foot peg
Locking space
Anchor
bolt
hole
Locking
peg
seated
inside
locking
space
Floor Lock
Bekijk gratis de handleiding van Vestil LAD-FM-96-PSO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-FM-96-PSO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6346 MB |
