Vestil LAD-6-21-P handleiding
Handleiding
Je bekijkt pagina 17 van 20
Table of Contents Rev. 11/18/2019 LAD (6-12 STEPS), MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 17 of 20
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
After assembling the ladder and before putting it into service, visually inspect the ladder. Record the condition and
appearance of each of the frame members (step weldment, back leg weldment, base support frame members), the
handrails, outriggers, wheels and/or casters, (leg) caps, back platform frame and chain, and all fasteners (bolts, nuts,
etc.). Thoroughly photograph the ladder from multiple angles. Include close range photographs of the rubber leg caps,
casters and wheels, all labeling, and all handrail connections. Add the photographs to the record. Collate all
photographs and writings into a single file. This file is a record of the ladder in satisfactory condition. Compare the
results of all inspections to this Record to determine whether the ladder is in satisfactory condition. Do not use the
ladder unless it is in satisfactory condition. Purely cosmetic changes, like damaged paint or powdercoat, are not
changes from satisfactory condition. However, touchup paint should be applied as soon as damage occurs.
NATIONAL STANDARDS
This product is a “mobile ladder stand” (MLS). ANSI standard A14.7 (the “Standard”) applies to MLS’s. You should
acquire a copy of the latest version of the standard. Follow all use and maintenance/care instructions provided in the
Standard as well as all other provisions for MLS owners and users. If any content in this manual conflicts with any
mandatory provision(s) in the Standard, apply the provision(s) from the Standard. Vestil encourages you to
immediately contact
Technical Service if you discover any inconsistencies.
USING THE LADDER
Review the SAFETY INSTRUCTIONS on p. 2 before using the ladder.
Inspect the ladder before each use for damage, such as unusual wear, deterioration, or corrosion. Tighten loose
nuts. If a lock nut has been partially or completely unfastened, it must be replaced with a new lock nut.
Make sure there are no children in the area where the ladder is used or stored.
Climbing the ladder:
ONLY use the ladder on even, level, improved surfaces (concrete or asphalt). Never use the ladder on angled
surfaces. The ladder must not wobble or lean while in use. Only climb the ladder when the steps and handrails are
clean and dry.
Stand on the bottom step. The front legs of the ladder should automatically lower into contact with the ground as
the caster brackets pivot upwards (caster brackets identified on p. 12). The rubber caps on the front legs (see Step 4
Step 7B: Install the handrails, handrail cross bar, and safety chain.
5
/
16
in. – 18
x 1
3
/
4
in. bolt
(11060)
5
/
16
in. – 18 lock nut
(37021)
Brake release
bracket
Cross bar
5
/
16
in. flat
washer
(33008)
3
/
8
” – 16 x
1
1
/
4
” bolt
(11107)
3
/
8
in. lock washer (33622)
Bekijk gratis de handleiding van Vestil LAD-6-21-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-6-21-P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8046 MB |
