Vestil LAD-16-14-P handleiding
Handleiding
Je bekijkt pagina 10 van 18
Table of Contents Rev. 12/2/2019 LAD (13-16 STEPS), MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 10 of 18
ASSEMBLING THE LADDER (AT LEAST 2 PERSONS ARE NEEDED)
Improper assembly might make this ladder unsafe to use.
• Visually inspect all ladder components immediately after delivery and before assembling the ladder for damage that might have
occurred during shipping. DO NOT assemble or use the ladder stand if you notice any damage to one or more of the steps or to
other structural element (step weldment, back leg weldment, base supports, and handrails) of the ladder. Using the ladder stand
with a weakened frame member could result in serious personal injuries.
• DO NOT assemble the ladder by yourself. Work with at least 1 other person to assemble the ladder.
• Read the entire instruction manual before assembling this ladder.
The following tools are necessary to assemble the ladder: a) 2 crescent wrenches (
5
/
16
” and
3
/
8
”); b) Rubber mallet.
Numbers in the diagrams and in parentheses () correspond to item numbers or part numbers in the bills of materials on pages
4, 5, 6, 7, & 8. Refer to the appropriate exploded view and bill of materials for your ladder while assembling it. NOTE: Step 1
depicts the step frame weldment with casters already installed. If your ladder is delivered without these casters installed, go to
INSTALLING CASTERS on p. 9. Install the casters; then proceed to step 1.
5
/
16
” – 18
lock nut
(37021)
Lower step
weldment
Hinge
plate
Upper step
weldment (1)
Hinge
bracket
Hinge
bracket
a
a
b
c
e
d
f
g
h
b
c
d
e
f
g
h
5
/
16
” – 18 x 1” bolt (11055)
1in. black
plastic plug
1in. x 1in.
square cap
Step 1: Attach the upper (1) and lower (2) stair weldments using hinge plates (11) using
5
/
16
” –
18 hardware as shown in the illustration below. Install bolts through the bolt holes in the hinge
plates and the hinge brackets highlighted with arrows. . Insert bolts through holes a-d to connect
the hinge plate to the upper step weldment; bolt holes e-h are used to fasten the hinge plate to
the lower step weldment. . Next, install the plastic plugs and square caps in the front legs. First,
press the 1in. plastic plug into the front legs. Then, press the square caps over the plugs and
onto the ends of the legs. If necessary, use a rubber mallet to gently tap the plugs and caps into
place
.
Bekijk gratis de handleiding van Vestil LAD-16-14-P, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-16-14-P |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7955 MB |
