Vestil JIB-HC-3 handleiding
Handleiding
Je bekijkt pagina 9 van 10
Rev. 10/17/2016 JIB-HC, MANUAL
Copyright 2016 Vestil Manufacturing Co. Page 9 of 10
Maintenance:
Lubricate pivot points whenever the boom is noisy while being rotated or when the resistance to rotation
increases.
At least once per month:
1. Check both wall mounting brackets and anchoring hardware. Make sure that the brackets are securely
anchored (i.e. do not wobble). Confirm that anchoring hardware is in normal condition. Replace an anchor if
it is loose, broken, or severely worn.
2. Examine both axles and the nuts and washers attached to them. Tighten all loose fasteners and replace an
axle that is damaged.
3. Inspect the sleeve bearings. Replace a bearing if it is substantially worn.
4. Check the inner bearing and the boom bearing for severe wear, bending, cracking and other forms of
damage. Replace the entire boom assembly if the boom bearing is damaged.
Labeling diagram:
Only use the dumper if it is labeled as diagrammed below. ALL labels must be readable and undamaged.
Replace all damaged/unreadable labels.
C (other side
of boom)
D
B: Label 560, 561, or 562 (both sides of jib; applied to black rectangle of label 391)
Or Or Or
A: Label 391 (both sides of jib) – Capacity
D: Label 287 – Product data label.
A + B
C: Label 586 (on other side of jib) – Hazards of use
Bekijk gratis de handleiding van Vestil JIB-HC-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | JIB-HC-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2200 MB |
