Vestil IBC-TLT-FP handleiding
Handleiding
Je bekijkt pagina 4 van 5
Table of Contents Rev. 10/22/2020 IBC-TLT, MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 4 of 5
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
After the unit is installed, make a detailed record of its condition. Include observations about all
features: pivot points, welds, the container support subassembly, and fork pockets. Thoroughly
photograph the unit from multiple angles so that all features are clearly imaged. Photograph all labels
applied to the stand. Describe where each label is located. Collate all photographs and writings into a
single file. This file is a record of the stand in satisfactory condition. Compare the results of each
inspection to this RECORD to determine if the unit is in satisfactory condition. Do not use the stand
unless it is in satisfactory condition
INSPECTIONS AND MAINTENANCE
Compare inspection results to the RECORD. Do not continue to use the product unless every
component is in SATISFACTORY CONDITION. Cosmetic changes, like damaged paint/powder coat do
not constitute changes from satisfactory condition. However, touchup paint should be applied to all
affected areas as soon as damage occurs. Contact TECHNICAL SERVICE to order replacement parts.
Contact information is provided on the cover page of this manual.
Inspect the following at least once per month:
1. Surfaces – Check all surfaces of the product for dirt or other matter, especially fluids. Clean the
surfaces of the stand.
2. Hardware, fasteners – Examine pivot point fasteners (bolts, nuts). Replace damaged/worn
hardware.
3. Frame & container support – Examine the frame and support for wear, breaks, corrosion/rust, metal
fatigue, and other forms of damage (e.g. impact damage).
4. Spring – Check the spring for cracks and other damage. Make sure that there is no debris caught in
the spring.
5. Labels– Replace labels that are damaged or not easily readable from a reasonable distance.
6. Overall structure – Examine the whole structure for rusting or metal erosion, rot, thinned regions. In
particular, examine pivot points and ground-contacting surfaces. If rusting is purely superficial,
remove the rust/corrosion. Clean the affected area and apply touchup paint. If rusting, rot, or
thinning has weakened the material, contact TECHNICAL SERVICE for advice.
LABELING DIAGRAM
Label content and locations are subject to change so your product might not be labeled exactly as
shown. Replace all labels that are damaged, missing, or not easily readable (e.g. faded). To order
replacement labels, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
. Alternatively, you may request replacement parts and/or
service by calling (260) 665-7586 and asking the operator to connect you to the Parts Department.
208 both sides
1049
287
Bekijk gratis de handleiding van Vestil IBC-TLT-FP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | IBC-TLT-FP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1593 MB |
