Vestil FL-4000 handleiding
Handleiding
Je bekijkt pagina 4 van 8
Table of Contents Rev. 8/21/2020 FL-4000 MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 4 of 8
SIGNAL WORDS
This manual uses SIGNAL WORDS to draw attention to uses of the product that could result in personal
injuries, as well as the probable seriousness of those injuries. Other signal words call attention to uses likely to
cause property damage. Signal words used in this manual appear below along with the definition of each word.
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or SERIOUS
INJURY. Use of this signal word is limited to the most extreme situations
.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or SERIOUS
INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or MODERATE
injury.
Identifies practices likely to result in product/property damage, such as operation that might
damage the product.
SAFETY INSTRUCTIONS
Vestil strives to identify all foreseeable hazards associated with the use of its products. However, material
handling is dangerous and no manual can address every conceivable risk. The most effective way to prevent
injury is to apply sound judgment whenever using this device.
Acquire a copy of the latest version of ANSI B56.1 (“B56.1” or the “Standard”). The Standard is freely
downloadable on www.ITSDF.org
. Apply all portions of Part II “For the User” about the use of attachments and
removable attachments. The following recommendations are intended to complement the provisions of B56.1.
Risk of serious personal injuries or death! Always apply the following safety instructions.
• Before this product may be used, U.S. Occupational Safety and Health Administration rule 1910.178(a)(4) and
(a)(5) require that the owner/user: 1) Obtain written approval from the manufacturer(s) of all forklifts [or from a
professional engineer] that will use the loader; 2) Change capacity, operation, and maintenance instruction
plates, tags, or decals accordingly; AND 3) Mark the forklift truck to identify the beam and show the approximate
weight of the truck and beam combination at maximum elevation with load laterally centered. Requirements are
published at https://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=STANDARDS&p_id=9828
• Read & understand this entire manual before using or servicing the loader.
• Inspect the loader as directed in the INSPECTIONS & MAINTENANCE section on p. 6. DO NOT use it unless it
is in SATISFACTORY CONDITION. See RECORD OF SATISFACTORY CONDITION on p. 6.
• DO NOT use the loader if the carriage chain is damaged or missing; DO NOT lift the loader until it is securely
connected to the carriage of the fork truck with the carriage chain. ONLY use this loader with a powered forklift
truck. DO NOT mount the loader on stackers or manually propelled lift trucks.
• DO NOT fill the loader with a load weighing more than its maximum rated load. See SPECIFICATIONS sections
on pages 2 and 3.
• NO ONE should travel under the loader at any time while it is elevated.
• NEVER wrap the release cable around your hand, fingers, or any other part of your body!
• Loaders with lifting lugs can be lifted with overhead hoists and cranes. DO NOT lift a loader unless the chute
is securely latched to the frame.
• DO NOT allow people to ride on or in the loader.
• DO NOT use the loader if any label is unreadable or missing. Apply replacement labels before returning the
loader to service. See LABELING DIAGRAM on p. 7.
• ALWAYS apply proper lift truck operation techniques learned during your training program. Before raising the
loader from the floor, tilt the (forklift) mast toward the cab of the truck to ensure that the loader will not slide off
of the forks.
• DO NOT modify the loader without first obtaining written approval from Vestil! Unapproved modifications might
make the loader unsafe to use and automatically void the LIMITED WARRANTY on p. 8.
• DO NOT dump the loader UNLESS every person in the vicinity is a safe distance away from the dumping site.
• DO NOT dump the loader if the forklift is on sloped terrain. Only dump the loader while on level surfaces.
• DO NOT exceed the load ratings or fill the loader above the side walls. Injury to personnel or permanent
damage to the equipment could result from overloading.
Bekijk gratis de handleiding van Vestil FL-4000, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | FL-4000 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2307 MB |
