Vestil EPT-2047-30 handleiding
Handleiding
Je bekijkt pagina 32 van 58
TABLE OF CONTENTS 5/19/2022 EPT MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Page 32 of 58
CHANGING THE THROTTLE ASSEMBLY
Estimated time: 30 minutes
Necessary tools:
5mm Allen wrench
Philips-blade screwdriver
Small Regular (flat) blade screwdriver
Only trained, authorized personnel should perform maintenance on this equipment. Lead acid
batteries present hazards to the person(s) working on, with, or in the vicinity of them. To minimize the risk of serious
personal injury, read every one of the instructions and DO NOT proceed with maintenance unless you understand
each of them.
• Lock out all potential energy sources (i.e. battery) before attempting this installation according to OSHA
lockout/tagout procedures (29 CFR 1910.147); turn off the unit and remove the key.
• DO NOT work on, with, or in the vicinity of the battery UNLESS you are wearing personal protective equipment,
particularly a face shield. Batteries contain sulfuric acid and produce explosive gases. A battery explosion could
result in loss of eyesight or serious burns.
• DO NOT smoke near the battery or expose the battery to sparks or flames.
• Charge batteries ONLY in clean, dry, and well-ventilated locations.
• DO NOT lay tools or anything metallic on top of a battery.
• Remove personal items like rings, bracelets, necklaces, and watches BEFORE beginning to work on the battery.
The battery can produce energy sufficient to weld jewelry to metal; underlying skin could be severely burned.
• Keep fresh water and soap nearby in case battery acid contacts skin, clothing, or eyes. Immediately rinse any
skin that has been contacted by acid. If acid gets in your eyes, rinse them thoroughly with eye wash. After
rinsing the affected area, notify your supervisor about the incident.
• DO NOT expose the unit or the charger to rain or other adverse conditions. ALWAYS return the unit to its
designated storage location when you finish using it. The designated storage location should offer protection from
the elements and should not interfere with or obstruct traffic.
• Replace defective cords or wires immediately.
• Routinely check the water level in the battery.
• Make sure the battery charger is unplugged from the 115V source BEFORE driving the unit.
• Operating the pallet truck when battery voltage is low can cause premature motor contact failure.
Turn off power to the pallet truck and remove the key.
Purpose: To repair a non-functional or malfunctioning belly switch, i.e. the batteries are fully charged, but the belly
switch does not function. The following procedure includes instructions for:
A) Replacing the entire throttle assembly, which incorporates the belly switch and throttle controls; AND
B) A method for restoring normal function to the belly switch mechanism.
Step 1: Open the throttle assembly by removing the three 5mm Allen head bolts from the underside of the handle (photo
1); then lift the base of the assembly away from the handle (photo 2).
1
2
5mm Allen screws
Throttle assembly
Handle
Bekijk gratis de handleiding van Vestil EPT-2047-30, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EPT-2047-30 |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 48560 MB |
