Vestil EPT-1940-26 handleiding
Handleiding
Je bekijkt pagina 4 van 51
Rev. 0213 EPT, Manual.doc
Copyright 2013 Vestil Manufacturing Corp. Page 4 of 51
b) Connect the sling to both hook points on the EPT (1 on each side; the picture below only shows the hook point
on the right side); then lift the unit no more than 6 – 8 inches above the pallet. The EPT will tilt towards the
control yoke. Additionally, it may swing from side-to-side once free of the pallet if you did not properly position the
hoist above the center of the sling. Stabilize the suspended truck with one hand, and stand safely to the side while
operating the hoist.
All Models: Securely connect the sling hooks to the hook points (see photographs below), lift the EPT a few
inches off of the pallet, direct the EPT away from the pallet, and then lower it until it is entirely supported by the
ground.
To lift the EPT with a forklift:
Avoid contacting the drive wheel with the tines of your
forklift; contact could damage the drive wheel.
Approach the pallet truck from the operator side. Lift the EPT just a few
inches above the pallet. Slowly back the forklift away from the pallet, and
then carefully lower the forks until the EPT rests firmly on the ground.
Operator
Side
Loading
side
Hook point
1
2
3
EPT-45 EPT-30
Bekijk gratis de handleiding van Vestil EPT-1940-26, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EPT-1940-26 |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 39822 MB |
