Vestil EHLT-TL-48144-4-46 handleiding
Handleiding
Je bekijkt pagina 15 van 22
Operator’s Manual 10/23/2023 EHLT-TL MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 15 of 22
RECORD OF SATISFACTORY CONDITION
After assembling and installing the scissor lift table, and before using it for the first time, make a record
describing its appearance. Thoroughly photograph the lift table from multiple angles, including all welds and anchor
points, and all labeling applied to it. Describe where each label is located. Collect all photographs and writings into a
file. Mark the file appropriately to identify it. This record documents satisfactory condition. Compare the results of
future inspections to this record to determine if the lift table is in satisfactory condition. Do not use the lift table
unless it is in satisfactory condition. Purely cosmetic changes, like damaged paint or powder coat, do not constitute
changes from satisfactory condition. However, touchup paint should be applied to all affected areas as soon as
damage occurs.
OPERATION INSTRUCTIONS
Consult ANSI standard MH29.1, Section 12 for explanations of the responsibilities of scissor lift table owner’s and
user’s regarding table operation, care, and maintenance.
The user shall ensure that operators understand that safe operation is the operator’s responsibility. The user shall
also ensure that operators are knowledgeable of, and observe, the safety rules and practices in this section.
EHLT-TL series scissor lift tables are suitable for use indoors in most non-classified industrial locations and many
commercial locations. They are intended to lift stable, evenly-distributed, nonhazardous materials loads having a size
or footprint approximately the same size as the platform.
The following drawing identifies the major components of your scissors lift table.
Loading the platform.
The load rating, in pounds, is shown on the machine data plate located on the end of the platform. This indicates
the net capacity of the scissor lift table for a static load, centered and evenly distributed on the platform. For off-
center loads, the lift table’s maximum capacity is 33% of the rated capacity when loads are applied to the end 25% of
the table (outer 50% of either leg set), and 50% for side loading (either side) (see diagrams).
Power unit
Maintenance prop
Perimeter toeguard
Scissor leg set
Platform
Cylinder
End loading
reduces
capacity to
33% of overall
capacity
Side loading reduces capacity
to 50% of overall capacity
Bekijk gratis de handleiding van Vestil EHLT-TL-48144-4-46, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EHLT-TL-48144-4-46 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5647 MB |
