Vestil EHLT-TL-30144-2-46 handleiding
Handleiding
Je bekijkt pagina 17 van 22
Operator’s Manual 10/23/2023 EHLT-TL MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 17 of 22
if you are uncertain how to address an issue discovered during an inspection. Technical Service can be contacted
by calling (260) 665-7586 and asking for the Service and Parts Department or by submitting questions online
through https://www.vestil.com/page-parts-request.php.
WARNING
Care should be taken to identify all potential hazards and comply with applicable safety procedures before
beginning work.
Remove any load and install the maintenance props before beginning any inspection or service on the lift table.
See below.
Only qualified individuals trained to understand mechanical devices, electrical and hydraulic circuits, and the
hazards associated with them, should attempt troubleshooting and repair of this equipment.
Inspection procedures.
Prior to performing any inspection or maintenance on this lift table:
Read and understand these maintenance procedures.
Remove the load from the platform. Do not attempt to service a loaded lift table.
Fully lower the platform, OR use both maintenance props to support the weight of the platform. To use the
maintenance props, raise the platform to its full height. Rotate both props forward so that their free ends drop
down into the lift table’s frame. Lower the platform until the maintenance props slide up against the end of
the frame.
Disconnect power and follow established lockout/tagout policies as required.
Initial inspection.
Prior to use, any new, altered, modified, or repaired scissor lift table shall be inspected by a qualified person.
Complete both the daily and monthly inspection items before releasing the lift table for regular use.
Daily inspection.
At the beginning of every shift, a designated person shall complete these inspections. Remove the lift table
from service and repair or replace any damaged parts if any of the following is found.
1. Look for:
a. Frayed wires.
b. Oil leaks.
c. Pinched, chafed, worn, or cracking hydraulic hoses.
d. Damage, deformation, or cracks in any structural member or any weld. Give special attention to
the hydraulic cylinder mounting brackets.
e. Loose or missing fasteners.
f. Unusual noise or evidence of binding.
2. Test the function of the upper travel limit switch and the perimeter toe guard.
Monthly inspection.
Have a qualified person inspect for:
1. Oil level. The oil should be 1” to 1-½” below the reservoir fill hole with the platform in the fully lowered
position. See the Annual Inspection section for the hydraulic oil specification.
2. Worn or damaged hydraulic hoses or electrical wires.
3. Wear in the pivot points on the legs.
4. Looseness or wear in the rollers.
5. Integrity of the retaining hardware on all rollers and all pivot point pins.
6. Integrity of the frame anchor bolts, and for cracks in the concrete around them.
Bekijk gratis de handleiding van Vestil EHLT-TL-30144-2-46, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EHLT-TL-30144-2-46 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5647 MB |
