Vestil CYHT-OL-9-150 handleiding
Handleiding
Je bekijkt pagina 6 van 7
TABLE OF CONTENTS Rev. 4/29/2021 CYHT-OL-9-150, MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Corp. Page 6 of 7
DON’T GUESS! If you have any questions about the condition of your lifter, contact the
TECHNICAL SERVICE
department. The phone number is provided on the cover page of this manual.
Never make temporary repairs of damaged or missing parts. Only use manufacturer-approved
replacement parts to restore the lifter to satisfactory condition.
Every lift
The operator of the lifter must inspect the lifter and cylinder surfaces before every lift. Check the lifter
and all cylinders for dirt or other surface debris. Clean the surfaces.
Monthly Inspections – At least once per month a qualified person must perform the following
inspections. Written reports should be prepared for every monthly inspection including inspections
following
LOAD TESTS.
1. Surfaces – Check all surfaces of the product for dirt or other matter, especially fluids. Clean the
surfaces of the stand.
2. Hardware, fasteners – Examine hardware & fasteners (axle pin, washers, cotter pins). Replace
damaged/worn hardware.
3. Wheels and axle – Check each wheel and wheel hub for damage such as cracks, significant or
uneven wear.
4. Frame – Examine the frame for wear, breaks, corrosion/rusting, metal fatigue, and other forms of
damage, e.g. impact damage.
5. Ratchet assemblies and straps – Check the ratchets and ratchet straps. Confirm normal operation.
Replace damaged straps and ratchets.
6. Bale and bale adjustment bar – Inspect the lifting bale. Confirm that the opening is not elongated,
widened, cracked, or otherwise damaged. The adjustment bar should not be cracked, warped, etc.
7. Labels – Replace labels that are damaged or not easily readable from a reasonable distance.
8. Overall structure – Examine the whole structure for rusting or metal erosion, rot, thinned regions. In
particular, examine the cylinder support and the axle pin channel, and. If rusting is purely superficial,
remove the rust/corrosion. Clean the affected area and apply touchup paint. If rusting, rot, or thinning
has weakened the material, contact TECHNICAL SERVICE
for advice.
LABELING DIAGRAM
Label content and locations are subject to change so your product might not be labeled exactly as
shown. Compare this diagram to the RECORD
. If differences exist between the diagram and the
RECORD, contact TECHNICAL SERVICE. Replace all labels that are damaged, missing, or not easily
readable (e.g. faded). To order replacement labels, contact the technical service and parts department
online at
http://www.vestilmfg.com/parts_info.htm. Alternatively, you may request replacement parts
and/or service by calling (260) 665-7586 and asking the operator to connect you to the TECHNICAL
SERVICE AND PARTS DEPARTMENT.
TAG 993 (obverse side)
TAG 993 (reverse side)
LABEL 658
Bekijk gratis de handleiding van Vestil CYHT-OL-9-150, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CYHT-OL-9-150 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1718 MB |
