Vestil CRP-120 handleiding
Handleiding
Je bekijkt pagina 5 van 6
Table of Contents Rev. 7/7/2023 CRP, MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 5 of 6
Annual evaluation — At least once per year, authorized inspection personnel should use the carpet pole to list
a full capacity load. Afterwards, conduct a Frequent Inspection to confirm that the product is in satisfactory
condition.
MAINTENANCE
End-users should implement a maintenance program to ensure that the product functions properly and is
adequately maintained. The OSHA “General Industry” standard for “Powered industrial trucks” (29 CFR
1910.178) provides recommended maintenance procedures for front end attachments. The following steps
should be utilized in conjunction with those procedures. ONLY trained, authorized personnel or contractors
should perform inspection, maintenance, or repair work.
NOTE: The end-user is responsible for selecting and training employees to work on the carpet ram. “Work on”
means use, inspect, and maintain the product.
Step 1: Tag the ram, “Out of Service.”
Step 2: Remove any dirt or other matter from all surfaces.
Step 3: Conduct a “Before each use” inspection. If deformity, corrosion, rusting, or excessive wear is found,
DO NOT use the product. Permanently remove it from service.
Step 4: Perform all necessary adjustments, replacements and/or repairs but DO NOT modify the ram.
NOTE: The reader should understand the significant difference between necessary adjustments and repairs,
and modifications. An “adjustment” is a simple correction that restores the device to satisfactory condition,
such as tightening loose fasteners, or removing dirt or other debris from the surface. “Repair” refers to
removing worn parts and installing replacement parts. A “modification” is a change that alters the carpet
pole from satisfactory condition, like bending the structural members or removing a part or several parts.
NEVER modify the device without the express, written approval of Vestil. Modifications might make the
device unsafe to use and automatically void the LIMITED WARRANTY on p. 6.
Step 5: Make a dated record of any repairs, adjustments and/or replacements.
LABELING DIAGRAM
The unit should be labeled as shown in the diagram. Label content and location are subject to change so your
product might not be labeled exactly as shown. Compare this diagram to your RECORD OF SATISFACTORY
CONDITION. Replace all labels that are damaged, missing, or not easily readable (e.g. faded). Order
replacement labels by contacting the TECHNICAL SERVICE & PARTS DEPARTMENT online at
https://www.vestil.com/page-parts-request.php. Alternatively, you may request replacement parts and/or service
by calling (260) 665-7586 and asking the
operator to connect you to the PARTS DEPARTMENT.
C: Label 1053 (Model, serial no., wt., capacity)
A: Label 985 (Proper installation)
D: Label 218 (Fasten safety chain to carriage)
A
C
D
B
B: Label 1049 (Forklift must be properly marked)
E: Label 1001 (This Side Up)
E
Bekijk gratis de handleiding van Vestil CRP-120, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CRP-120 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1452 MB |
