Vestil CRP-120 handleiding
Handleiding
Je bekijkt pagina 2 van 6
Table of Contents Rev. 7/7/2023 CRP, MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 2 of 6
SIGNAL WORDS
SIGNAL WORDS appear in this manual to draw the reader’s attention to important safety-related
messages. The following are signal words used in this manual and their definitions.
SAFETY INSTRUCTIONS
Vestil strives to identify foreseeable hazards associated with the use of its products, but no manual can
address every conceivable risk. Minimize the likelihood of injury by observing the hazards identified below
and by inspecting and maintaining the product as instructed in INSPECTIONS & MAINTNENANCE on p. 20.
WARNING
Risks of serious personal injuries or death. Always apply material handling techniques learned during
training and use the product properly.
Read and understand the entire manual before assembling, using or servicing the product.
Before using this (forklift) front end attachment, you must contact the manufacturers of all forklifts that
will use it to request: 1) written approval; and 2) markings for each forklift that identify the coil carrier AND
give the approximate weight of the forklift and carrier at maximum elevation with a laterally-centered
load. DO NOT use the carpet ram until your forklifts are marked.
Read and understand the entire manual before installing, using, or servicing the product. Read the
manual to refresh your understanding of proper use, inspection, and maintenance procedures whenever
necessary.
DO NOT exceed the capacity of your unit. See LABELING DIAGRAM, label 1153 on p. 5.
Inspect the carpet pole before each use as described in INSPECTIONS on p. 4-5.
Before attaching the carpet ram to the carriage of your fork lift, inspect the carriage and confirm that
all parts are structurally sound and in satisfactory condition. See RECORD OF SATISFACTORY CONDITION
on p. 4.
Always connect the safety chain to the carriage of your forklift without slack. The unit must not be able
to slide on the forks.
Verify that the load is stable by lifting the carpet just a few inches above the ground. Load swing
should be minimal and the carpet pole should not shift on the forks. If the load is not stable while
elevated, return it to the ground and use another device to transport it.
ALWAYS apply the rules governing use of (forklift) front end attachments applied at your work site.
DO NOT cover or remove any label. Verify the location and legibility of all labels. Label placement is
shown in the LABELING DIAGRAM on p. 5. DO NOT use this device UNLESS all product labels are readable
and undamaged.
DO NOT ride or sit on the carpet pole.
DO NOT use the carpet pole to push objects. Only use the product to transport a roll of carpet.
ONLY use this product when traveling on firm, level, even ground.
Carpet roll must not be longer than the pole. The carpet roll must not hang over the end of the pole.
See USING THE CARPET RAM on p. 4 for loading instructions.
DO NOT leave elevated rolls of carpet unattended. Always lower the load to the ground before
leaving the forklift.
DO NOT modify the carpet pole in any way UNLESS you first obtain written approval from Vestil.
Unauthorized modifications automatically void the LIMITED WARRANTY (see p. 6) and might make the
product unsafe to use.
DANGER
Identifies a hazardous situation which, if not avoided, WILL
result in DEATH or SERIOUS
INJURY. Use of this signal word is limited to the most extreme situations.
WARNING
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
CAUTION
Indicates a hazardous
situation which, if not avoided, COULD result in MINOR or
MODERATE injury.
NOTICE
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
Bekijk gratis de handleiding van Vestil CRP-120, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CRP-120 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1452 MB |
