Handleiding
Je bekijkt pagina 5 van 19
Table of Contents 9/3/2019 COLA MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Corp. Page 5 of 19
RECORD OF SATISFACTORY CONDITION:
After assembling and installing the crossover ladder, and before using it for the first time, make a record
describing its appearance. Thoroughly photograph the unit from multiple angles including all anchor points and all
labeling applied to it. Describe where each label is located. Collate all photographs and writings into a file. Mark the
file appropriately to identify it. This record documents satisfactory condition. Compare the results of all inspections
to this record to determine if the unit is in satisfactory condition. Do not use it unless it is in satisfactory condition.
Purely cosmetic changes, like damaged paint/powder coat do not constitute changes from satisfactory condition.
However, touchup paint should be applied to all affected areas as soon as damage occurs.
INSPECTIONS AND MAINTENANCE
Proper maintenance is essential for maximizing the service life of the unit. If an inspection reveals any
irregularities in the condition of the unit, repair it before returning it to service. Only use manufacturer-approved
replacement parts. Contact Technical Service if you have questions that are not addressed in these instructions or
if you are uncertain how to address an issue discovered during an inspection. Technical Service can be contacted
by calling (260) 665-7586 and asking for the Service and Parts Department or by submitting questions online at
http://www.vestilmfg.com/parts_info.htm.
Inspect and maintain the following components at least once per month as described:
1. Stairway: Examine the stairway for damage such as cracked metal, cracked welds, broken rungs, severe rusting
or corrosion. Repair damaged welds. Appropriately patch damaged metal. Closely examine the mounting plates
and anchor points, since they are in direct contact with the ground. Make sure that all anchor bolts are tightly
fastened to the ground. Gently remove rust/corrosion and clean the affected areas. Apply touchup paint to the
areas as soon as they dry. Periodically clean dirt and debris from all surfaces—especially steps—to keep the
finish in good condition. Slippery substances, such as grease and oil, must be cleaned from the steps as soon as
contact occurs. Apply touchup paint to all areas where the finish is damaged.
2. Handrails: Inspect the handrails for punctures, bends, cracks, and other damage. Closely examine all hardware
(bolts, nuts, washers). Tighten loose connections. Replace damaged hardware.
3. Labeling: Make sure all labels are in place & in easily readable condition. See Labeling diagram on p. 18.
STEP 4: Attach the top and middle handrail assemblies to the upper handrails with
3
/
8
”-16 hardware (11105 &
37024). The handrail couplers attach to the outsides of the handrail tabs.
STEP 5: Anchor the unit to the ground with
1
/
2
” anchor bolts. Your building engineer should determine the
necessary length of the bolts. Mark the floor with the locations of the anchor bolt holes in the mounting plates.
Then install the anchors and solidly fasten the ladder to the ground.
Handrail tab
Anchor
bolt holes
Anchor
bolt holes
Bekijk gratis de handleiding van Vestil COLA-2-56-20, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | COLA-2-56-20 |
| Categorie | Ladder |
| Taal | Nederlands |
| Grootte | 6717 MB |
