Handleiding
Je bekijkt pagina 3 van 23
PDSC-350-62, Manual
Copyright 2020 Vestil Manufacturing Corp.
SAFETY GUIDELINES
Failure to read and understand the instructions included in this manual before using or servicing
the stacker constitutes misuse of the product. Study the entire manual before you use the Climber for
the first time and before each subsequent use. Read the manual to refresh your understanding of the safe
use and maintenance procedures. If questions remain after you finish reading the manual, contact Vestil for
answers. DO NOT attempt to resolve any problem with the stacker unless you are certain that it will be safe to
use afterwards.
To decrease the risk of electrocution:
DO NOT contact or operate the climber close to electrified wires or other sources of electricity;
Before operating the Climber, always inspect the area where you will use it.
Improper use might result in serious personal injuries to the operator and/or bystanders. To
minimize the possibility of injury, ALL persons who might operate, perform maintenance on, or service the PDSC
must read, understand and apply the following instructions:
DO NOT operate the Climber unless and until you are:
1. Trained to use the machine; AND
2. Certified as a trained operator by your employer in accordance with U.S. OSHA regulations (29 CFR
§1910.178) and any standards incorporated by reference (e.g. ANSI/ITSDF B56.1-2005).
DO NOT attempt to transport loads that exceed the rated capacity.
Inspect the machine before each use; DO NOT use the Climber unless it is in normal condition. Normal
operating condition exists if PDSC passes the inspection and functions tests.
DO NOT use the unit until you read and understand the entire owner’s manual. Review the manual before
each use AND before performing maintenance on the device.
DO NOT use the Climber if the load-supporting elements sustain any structural damage. Structural elements
include, but are not limited to, the nose plate, frame, and wheels. If structural damage is present,
immediately tag the unit “Out of Service” and inform maintenance personnel of the problem.
DO NOT use the Climber if it makes unusual noises during operation.
DO NOT attempt to climb with unevenly distributed load. Always center, evenly distribute and secure load with
the frame
Before initial operation, check the electronic functions, safety brakes and position of the clmibing
wheel
DO NOT overload the unit.
Operator should be fully trained to operate the electric climber. Operator should be physically
experienced to handle the climber and load on the stair climber while moving up & down on the
stairs
Wear non-slip footwear and must operate unit with both hands
Practice operating PDSC without load and at low speed to start with. This will help operatior to get
familiar with the unit and how to operate the unit with load
Ensure load is secrued to frame with safety belt
Page 3 of 22
Bekijk gratis de handleiding van Vestil COL-3-26-33, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | COL-3-26-33 |
| Categorie | Ladder |
| Taal | Nederlands |
| Grootte | 5958 MB |
