Vestil BTT-6-36 handleiding
Handleiding
Je bekijkt pagina 9 van 10
0813 Rev. 5/20/2014 BTT, manual.doc
Copyright 2014 Vestil Manufacturing Co. Page 9 of 10
Power-actuated models (BTT 5-36; BTT-5-46; BTT-10-36; & BTT-10-46
The deck can be inclined at any angle from zero up to 45 degrees. To incline the deck, simply press the
“UP” pushbutton on the pendant controller until the deck achieves the degree of tilt desired. To decrease
the angle, press the “DOWN” button. Always return the deck to the horizontal configuration before leaving
the tilter unattended.
Inspections & Maintenance Recommendations
Inspect the tilter at least as frequently as indicated in this section to confirm that the tilter is in normal
operating condition.
Before each use, inspect the listed components. Do not use the tilter unless all components are in normal
condition:
1. Frame assembly: confirm that the frame is securely anchored to the surface.
2. Hinge link assembly (powered units): confirm that the link assembly is not warped or cracked
3. Electrical cords (powered models): check the cords for damage.
4. Crossbar support (manual models): examine the crossbar and confirm that it is structurally sound.
For example, it should not be warped, cracked, bent, or excessively rusted or corroded.
5. Product labels: all labels should be readable and located as shown in FIG. 6. If a label(s) is
unreadable or missing, contact Vestil to order a replacement.
At least 1 time per month, inspect:
1. Fasteners (hardware): anchoring hardware, bolts, nuts, washers, pins, washers, etc. Tighten loose
fasteners and replace any fastener that is damaged;
2. Handle: confirm that the handle is structurally sound, uncorroded and free of rust.
3. Welds: confirm that all welds are intact.
4. Linear actuator: cycle the actuator to confirm normal operation. Incline the deck to 45 degrees and
return the deck to the horizontal configuration, while:
a. Listening for unusual noises.
b. Watching the motion of the deck. Motion should be smooth and continuous.
Partly incline the deck and confirm that the actuator maintains deck position, i.e. the deck should not
lower on its own.
5. Overall condition of the tilter: the structure should be clean, square and rigid, and free of rust and
corrosion. Remove dirt and debris.
Label placement diagram
Each tilter should be labeled as shown on this page. Replace any label that is damaged or unreadable.
DO NOT use the tilter unless all labels are in place.
Label 287
Label 208
Bekijk gratis de handleiding van Vestil BTT-6-36, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | BTT-6-36 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2368 MB |
