Vestil BOL-R-42-5.5 handleiding
Handleiding
Je bekijkt pagina 4 van 5
TABLE OF CONTENTS 2/4/2022 BOL-R MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Page 4 of 5
INSTALLING THE BOLLARD
Step 1: Refer to FIG. 2. To prevent water from collecting in the sleeve, use a
10–12in. (25-30cm) piece of 1½ in. outer diameter PVC tube to function as a
drain pipe. Insert the tube into the drain hole in the bottom of the sleeve.
The top of the tube should be approximately flush with the top of the
bottom plate of the sleeve. Affix the drain tube to the sleeve with silicone
adhesive. Allow the adhesive to dry before proceeding to step 2.
Step 2: Dig a 20 inch x 20 inch hole (~51cm x 51cm) approximately 24 inches
deep (61cm) to contain the concrete. Center the hole on the location
where you wish to install the bollard. Fill the bottom of the hole with ~12
inches of gravel and then set the sleeve in the center of the hole. Press the
PVC drain into the gravel until the top of the sleeve is slightly above ground
level. See
FIG. 3.
Step 3: Partially fill the hole with 3,000psi compression
rated concrete into the hole; stop filling when the
surface of the concrete is a few inches below the top
of both the sleeve and the hole. Check the vertical
levelness of the sleeve. Adjust the position of the
sleeve if necessary. DO NOT get concrete inside the
sleeve. Allow the concrete to cure according to the
instructions that accompany the concrete mixture.
Step 4: Press the rubber cap into the opening at the
top of the bollard. See FIG. 4.
Step 5: Lower the bollard into the sleeve. See
FIGS. 5A
& 5B. Press the bollard down until in contacts the
bottom of the sleeve.
INSPECTIONS
Regular maintenance is essential for maximizing the service life of this product. At least once per
month, remove the bollard from the sleeve. Examine the bollard, particularly the bottom portion.
Remove rust/corrosion and apply touchup paint wherever the finish/paint is damaged. Inspect the
inside of the sleeve for rust and other forms of damage. Remove rust. A thin layer of oil can be applied
to the inside of the sleeve.
DON’T GUESS! Contact TECHNICAL SERVICE
if you have questions that are not addressed in these
instructions or if you are uncertain how to address an issue discovered during an inspection. Technical
Service can be contacted by calling (260) 665-7586 and asking for the Service and Parts Department
or by submitting your questions through Vestil’s online parts and service portal at
https://www.vestil.com/page-parts-request.php.
FIG. 3: Ground preparations
FIG. 2: Sleeve with
drain tube
Soil
FIG. 5A: Install
bollard
FIG. 5B: Top
view of sleeve
Bottom of
bollard
Sleeve
Concrete
Gravel
FIG. 4: Install
the cap
Bekijk gratis de handleiding van Vestil BOL-R-42-5.5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | BOL-R-42-5.5 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1012 MB |
