Vestil BOL-EAP-R-3-8X8 handleiding
Handleiding
Je bekijkt pagina 4 van 5
TABLE OF CONTENTS Rev. 5/16/2022 BOL-EAP MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Corp. Page 4 of 5
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Before installing this product, create a record of its appearance and features. Include written
descriptions of the mounting plates and the resilient material (identified in SPECIFICATIONS
section on p. 3). Thoroughly photograph the unit and all labeling applied to it. Collate the
writings and photographs into a single file. This file is a record of the unit in satisfactory condition.
Compare all inspection results to this record to determine if the unit is still in satisfactory
condition. Restore the absorber to satisfactory condition BEFORE continuing to use it. If the
absorber cannot be repaired, remove it from service. Purely cosmetic changes, like damaged
surface coating (paint or powdercoat) are not changes from satisfactory condition. However,
touchup paint should be applied as soon as damage occurs to prevent rusting.
INSPECTIONS & MAINTENANCE
Inspections and repairs should only be performed by qualified persons. Compare the results of
each inspection to the RECORD OF SATISFACTORY CONDITION (the “RECORD”). Do not
continue to use the absorber unless all parts are in satisfactory condition. DON’T GUESS! If you
have any questions about the condition of your absorber, speak with TECHNICAL SERVICE
personnel. The phone number is provided on the cover page of this manual. Never make
temporary repairs of damaged or missing parts. Only use manufacturer-approved replacement
parts.
At least once per month and immediately following any substantial contact/collision:
1. Check the surface of the product for dirt or other matter. Clean the surfaces.
2. Examine hardware including, but not limited to, anchor bolts, bolts, nuts, and washers.
Replace damaged, worn, or corroded hardware.
3. Examine the resilient material for cracks, tears, breakages, erosion, pitting, etc.
4. Inspect the mounting plates for corrosion and rusting.
5. Check the labels. Replace any label that is damaged or not easily readable. See LABELING
DIAGRAM on p. 5.
6. Examine the whole structure for severe rusting/metal erosion, rot, thinned regions. If rusting
is purely superficial, remove the rust/corrosion with a steel bristle brush or steel wool. Clean
the affected area and apply touchup paint. If rusting, rot, or thinning has weakened either
mounting plate, contact TECHNICAL SERVICE for advice.
LABELING DIAGRAM
Label content and location are subject to change. Your product might not be labeled
exactly as shown in the diagram (below). Replace all labels that are damaged, missing, or not
easily readable (e.g. faded). To order replacement labels, contact the TECHNICAL SERVICE
AND PARTS DEPARTMENT online at http://www.vestilmfg.com/parts_info.htm
. Alternatively, you
may request replacement parts and/or service by calling (260) 665-7586. Ask the operator to
connect you to the
PARTS DEPARTMENT.
Label 1112, applied to both plates
Label 204
Bekijk gratis de handleiding van Vestil BOL-EAP-R-3-8X8, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | BOL-EAP-R-3-8X8 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1007 MB |
