Vestil AHSN-6-10-16-VG handleiding
Handleiding
Je bekijkt pagina 18 van 26
Table of Contents Rev. 5/28/2025 AHSN, MANUAL
Table of Contents Copyright 2025 Vestil Manufacturing Co. Page 18 of 26
ASSEMBLING THE CRANE
If the crane is improperly assembled, it might malfunction and result in serious personal
injuries. Read this instruction manual in its entirety before assembling the crane; only assemble the crane
if you fully understand both the associated risks and the manufacturer-approved assembly procedure
discussed below.
ONLY qualified personnel should assemble the crane.
DO NOT modify the crane in any way unless and until you receive written approval from Vestil.
DO NOT use the crane if you notice damage to or deformation of the beam, uprights, or any
component of either of the leg assemblies. Using the crane despite weakness of a structural
component could result in crane collapse.
DO NOT use the crane if any of the hardware (bolts, nuts, clamps, etc.) is damaged; you could
sustain serious injuries if the crane collapses. Contact Vestil to order replacement parts.
DO NOT use the crane if any caster is damaged. A damaged caster may cause the crane to tip
over while hoisting or supporting a load.
Modifying the crane in any way without first receiving written approval of the modification from Vestil
automatically voids the limited warranty.
The crane is designed for both indoor and outdoor use. However, it should be sheltered from the
weather when not in use.
Inspect the crane for damage before each use.
Step 1a: Insert the leg weldments into the leg yoke; then secure the legs in place by installing
3
/
4
in. – 10 x
1½in. bolts through the
3
/
4
in. square nuts welded to the outer surface of the leg tubes.
Yoke
Leg
weldment
3
/
4
in. – 10 x 1½in. bolt
3
/
4
in. nut
welded
onto leg
tube
[AHSN-6, AHSN-8, and AHSN-10 models only]
Step 1b: Attach cross brace (28-514-246) and cross brace bolt plate (28-514-259) to bottoms of legs; then
fasten the cross brace to the bolt tab with
3
/
8
in. hardware.
Cross brace
bolt plate
5
/
16
in. – 18 x
3
/
4
in.
bolt
3
/
8
in. – 16 x
2in. bolt
bolt
3
/
8
in. flat
washer
bolt
3
/
8
in. – 16 hex nut
3
/
8
in. flat
washer
Cross brace
bolt plate
Bekijk gratis de handleiding van Vestil AHSN-6-10-16-VG, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | AHSN-6-10-16-VG |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6579 MB |
