Vestil AHS-8-20-14 handleiding
Handleiding
Je bekijkt pagina 18 van 26
TABLE OF CONTENTS Rev. 5/23/2025 AHS MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Corp. Page 18 of 26
ASSEMBLING THE CRANE
If the crane is improperly assembled, it might malfunction and result in serious personal
injuries. Read this instruction manual in its entirety before assembling the crane; only assemble the crane
if you fully understand both the associated risks and the manufacturer-approved assembly procedure
discussed below.
ONLY qualified personnel should assemble the crane.
DO NOT modify the crane in any way unless and until you receive written approval from Vestil.
DO NOT use the crane if you notice damage to or deformation of the beam, uprights, or any
component of either of the leg assemblies. Using the crane despite weakness of a structural
component could result in crane collapse.
DO NOT use the crane if any of the hardware (bolts, nuts, clamps, etc.) is damaged; you could
sustain serious injuries if the crane collapses. Contact Vestil to order replacement parts.
DO NOT use the crane if any of the casters is damaged. A damaged caster may cause the crane to
tip over while hoisting or supporting a load.
Modifying the crane in any way without first receiving written approval of the modification from Vestil
automatically voids the limited warranty.
The crane is designed for both indoor and outdoor use. However, it should be sheltered from the
weather when not in use.
Inspect the crane for damage before each use.
Step 1A: Fasten the uprights to the leg assemblies (FIG. 1A); then fasten two beam clamps to the beam
bracket (FIG. 1a shows diagram for All AHS models except those listed in Step 1B). Lay the leg
assemblies (2) flat on the ground. Then, slide the uprights (3) into the corresponding sleeves of the leg
assemblies. Insert the telescoping tubes (uprights) until the 3
rd
pinhole in the uprights aligns with the
pinhole in the leg assemblies as indicated in Fig. 1A below. Each upright must be pinned to a leg
assembly through the same pinhole (diagram below shows pinning through 3
rd
pinhole). To pin an
upright to a leg assembly, use a 1 in. x 6 in. retaining pin (see exploded parts diagram that corresponds
to your crane model).
FIG. 1a: Beam Clamp-to-Beam Bracket
Connection
½ in. -13 x 2in.
A325 structural bolt
Welded beam clamp
½ in. -13 A325
structural nut
½ in. zinc-plated
lock washer
FIG. 1A: Upright-to-Leg Assembly
Connections
10
or
11
Pin upright to
leg assembly
Retaining pin
(part no. 28-612-003)
Bekijk gratis de handleiding van Vestil AHS-8-20-14, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | AHS-8-20-14 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6431 MB |
