Vestil AHS-6-15-9 handleiding
Handleiding
Je bekijkt pagina 22 van 26
TABLE OF CONTENTS Rev. 5/23/2025 AHS MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Corp. Page 22 of 26
USING THE CRANE
Before using the crane for the first time, perform a BEFORE AND AFTER EACH USE inspection (see p. 24).
Crane operators are responsible for operating the crane in a safe manner. To reduce the
likelihood of serious personal injuries or death resulting as a consequence of negligent operation:
Only qualified, designated crane operators should use this device. The operating instructions in this
manual supplement safe crane and hoist operation practices learned during your training program.
ALWAYS apply the safe material handling practices learned during your training program (for
example, practical operating examination).
All personnel not participating in crane use must stay out of the crane operation area during use. Be
certain no part of any person or object is under any part of the boom (I-beam) or the suspended load
at any time and particularly before lowering it. Instruct all persons to remain at a safe distance during
operation.
Always carefully watch the boom and any load hanging from it while using the crane.
Always follow the hoist and trolley manufacturers’ instructions regarding proper use of their products.
BEFORE the load is connected to the hoist, lock or immobilize the casters (for instance with chocks).
DO NOT use the crane and notify your supervisor and authorized maintenance personnel if: 1) you
observe any damage or hear unusual noise during operation; 2) if you observe any warping or
deformation of the beam, the uprights, the load hook or chain (or cable).
Height adjustment:
Support the I-beam so that the height adjustment pins can be
removed, for instance with the tines of a fork truck or by
attachment to an overhead hoist. Raise the beam to the desired
height; then pin the uprights to the leg assemblies. Each pin must
extend completely through the leg assemblies. See Fig. 6.
Proper loading:
Position the trolley and hoist directly above the load. Proper
centering requires the operator to center the trolley and hoist
above the center of the load as well as to position the long axis of
the I-beam above the center of the load. Proper positioning is
diagrammed below in Fig 7.
FIG. 7: Proper Load Lifting
Fig. 6: Pin upright at selected height
Height
adjustment
pin
Cotter
pin
Upright
Leg
assembly
Properly centered hoist & trolley
Improperly centered hoist & trolley
Bekijk gratis de handleiding van Vestil AHS-6-15-9, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | AHS-6-15-9 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6431 MB |
