Handleiding
Je bekijkt pagina 17 van 21
EN - 17
4. USE OF PRODUCT
4.1 Use of Gas Burners
Ignition of the burners
The position symbol above each control knob
indicates the burner that the knob controls.
Manual Ignition of the Gas Burners
If your appliance is not equipped with an ignition
aid, or in case there is a failure in the electric
network, follow the procedures listed below.
For Hob Burners: Push in the knob of the burner
you wish to ignite and keep
it pressed while turning it anti-clockwise until the
knob is in the ‘maximum’ position. Continue
pressing the knob and hold a lit match, taper or
other manual aid to the upper circumference of
the burner. Move the ignition source away from
the burner as soon as you see a stable flame.
Electrical ignition by control knob
Push in the kn
ob of the burner you wish to
ignite and keep it pressed while turning it anti-
clockwise until the knob is in the 90 degrees
position.The microswitch under the knob will
create sparks through the spark plug for as long
as the control knob is pressed. Press the knob
until you see a stable flame on the burner.
Flame safety device
Hob burners
Hobs equipped with a flame failure device
provide security in case of an accidentally
extinguished flame. If such a case occurs, the
device will block the burners gas
lines and will avoid any accumulation of
unburned gas. Wait 90 seconds before
re-igniting an extinguished gas burner.
Hob Controls
Hob burner
The knob has 3 positions: off (0), maximum (big
flame symbol) and minimum (small flame
symbol). Ignite the burner with the knob in the
'maximum' position; you can then adjust the
flame length between the
'maximum' and 'minimum' positions. Do not
operate the burners when the knob is between
the 'maximum' and 'off' positions.
OFF position
MAX position
MIN. position MODULATE
After ignition, visually check the flames. If you
see a yellow tip, lifted or unstable flame, switch
the gas flow off, then check the assembly of
burner caps and crowns once they have
cooled. Make sure there is no liquid in the
burner caps. If the burner flames go out
accidentally, switch the burners off, ventilate
the kitchen with fresh air and wait at least 90
seconds before attempting re-ignition.
Cap
Crown
Spark
plug
Burner
cup
T
o switch the hob burners off, turn the hob
burner knob clockwise to the ‘0’ position or so
that the marker on the hob burner knob points
upwards.
Your hob has burners of different diameters. You
will find that the most economical way of using
gas is to choose the correct size gas burner for
your cooking pan size and to bring the flame to
the 'minimum' position once boiling point is
reached. We recommend that you always cover
your cooking pan to avoid heat loss.
To obtain maximum performance from the main
burners, we suggest you use pots with the
following flat bottom diameters. Using pots
smaller than the minimum dimensions shown
below will cause energy loss.
Bekijk gratis de handleiding van Vestel AO-65104 BDG-DW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | AO-65104 BDG-DW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 1664 MB |
