Handleiding
Je bekijkt pagina 28 van 75
English - 27 -
Antenna type selection screen may be
displayed next. You can select Antenna
type as Direct, Single Satellite Cable
or DiSEqC switch by using the Left
or Right directional buttons. After
selecting your antenna type press
OK. On the next screen press OK to
see the options to proceed. Continue,
Transponder list and Configure
LNB options may be available. You
can change the transponder and
LNB settings using the related menu
options.
• Direct: If you have a single receiver
and a direct satellite dish, select this
antenna type. Press OK to continue.
Select an available satellite on the
next screen and press OK, highlight
Continue and press OK again to scan
for services.
• Single Satellite Cable: If you have
multiple receivers and a single satel-
lite cable system, select this antenna
type. Press OK to continue. Configure
settings by following instructions on
the next screen. Press OK, highlight
Continue and press OK again to scan
for services.
• DiSEqC switch: If you have multiple
satellite dishes and a DiSEqC switch,
select this antenna type. Then set
the DiSEqC version and press OK
to continue. You can set up to four
satellites (if available) for version
v1.0 and sixteen satellites for version
v1.1 on the next screen. Press OK,
highlight Continue and press OK
again to scan the selected satellite/s.
Note: Depending on the model of your TV, DiSEqC version v1.1
may not be supported and therefore the DiSEqC version selection
step may not be available.
TKGS (Türksat Kanal Güncelleme
Sistemi) Installation
If desired, you can start a TKGS
installation if the Satellite broadcast
search option is turned on. In order to
start a TKGS installation set the Install
Type as Operator when prompted
and then set the Satellite Operator
as TKGS. Then press the OK button
to start TKGS installation. Set your
antenna type as described above.
You can select to install HD or SD
channels during the installation.
This selection can be changed later
using the Preferred List option under
the Settings>Installation>TKGS
Installation menu. The selection will
be activated, after switching the TV o
and back on again or after a manual
update as described below.
Optionally, the TKGS Installation can
be applied manually after the first time
installation. Go to Home screen and
select Settings>Installation>Satellite
Settings>Antenna installation. After
selecting your antenna type and then
the satellite on the next screen, press
OK. Options menu will be displayed.
You can change the transponder and
LNB settings using the related menu
options. Once the satellite settings
have been made, highlight the TKGS
Bekijk gratis de handleiding van Vestel 50UT9850, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | 50UT9850 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 8015 MB |
