Handleiding
Je bekijkt pagina 23 van 87
English - 22 -
Note: If the country selected does not
have analogue broadcasts, analogue
channels may not be searched.
Once you are done with setting
available options, highlight Scan and
press OK to proceed. The TV will start
to search available broadcasts.
While the search continues you can
press the Back/Return button to stop
the search. The channels that have
already been found will be stored in
the channel list.
Satellite
If the Satellite option is selected,
the Antenna type screen will be
displayed next. If you have a Direct
satellite system, you can proceed
to the next step quickly by selecting
the Next step option here. Highlight
More and press OK to set the antenna
type manually. Single, Tone Burst,
DiSEqC, and Unicable options are
available. Highlight the antenna type
that corresponds to your satellite
system and press OK to proceed to
the next step.
Next screen may be the Select channel
list screen. Available operators will be
listed. You can select only one operator
from the list. Highlight the desired
operator and press OK to proceed.
Some of the options in the following
steps may be preset and/or additional
steps may be added or some steps
may be skipped depending on the
selected operator in this step. Check
the parameters in each step before
proceeding and adjust if necessary.
You can highlight General and press
OK to proceed with normal satellite
installation.
LNB list screen will be displayed next.
You may be able to set up dierent
satellites depending on the selected
country, antenna type and operator
in the previous steps. Highlight the
desired satellite option and press OK
to set the parameters. The Satellite
status of the first satellite option
will be set as On. In order to enable
channel scan on the satellite, this
option should be set as On rst.
Following satellite parameters will
be available. You may not be able to
change all settings depending on the
previous selections.
Satellite status: Set the status
option to On to enable channel
search on the selected satellite.
Satellite selection: Select the satellite
on which you want to perform a
channel search.
Scan mode: Set your scan mode
preference. Network and Full
options will be available. If you are
going to perform a network scan,
make sure that you have adjusted the
Frequency, Symbol rate (Ksym/s),
and Polarisation parameters under
the Transponder option accurately.
Scan type: You can perform a scan
for free or encrypted channels only. If
the Free option is selected, encrypted
Bekijk gratis de handleiding van Vestel 50UG9750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | 50UG9750 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 8815 MB |
