Handleiding
Je bekijkt pagina 31 van 84
30
EN
3. INSTALLATION
1. Unpack
Remove the packaging materials and dispose of them properly. Check that the appliance is not damaged. Do not
connect the appliance if it is damaged. Report any damage immediately to the salesperson via customer service. In
that case, keep the packaging.
2. Location
• The location where you place your appliance should be well ventilated.
• Always move the appliance with two people. Use two hands when moving, lifting or turning the appliance.
• Do not place the appliance near a heat source, such as a stove or boiler, and avoid direct sunlight, so as to
guarantee the cooling effect and save on energy consumption.
• Do not place the appliance in a damp place so that it cannot rust and there is no leakage current.
• Do not use the appliance outdoors. This appliance is only intended for use indoors.
3. Installation of the appliance
• This appliance is not intended for use as a built-in appliance.
• Use only the original accessories provided for the installation.
• To reverse the direction in which the door opens, go to section
3.2.
• During operation, the appliance emits heat to the environment.
Therefore there must be at least 5 cm clearance on the top, at
least 5 cm on both sides and at least 5 cm on the back of the
appliance (see also section 2.1).
• Use the front adjusting legs to level the appliance. If the
appliance is not level, it is possible that the door may not close
properly, reducing the cooling performance of the appliance. If
the appliance is not level, this can also lead to malfunctions.
• Make sure that the power cable is not stuck or damaged during
installation or positioning the appliance.
• It must be possible to disconnect the appliance from the mains
power supply. The plug must therefore be easily accessible after
installation.
• Always place the appliance on a moisture-resistant and dry
surface.
• Place the appliance on a rm and at surface (oor) so that it is
stable, otherwise vibrations and noise may occur. When placing
the appliance on oor coverings such as carpets, straw mats or
polyvinyl chloride (PVC), place a solid sheet or cover under the
appliance to prevent colour change due to heat dissipation.
4. Adjusting the doors
Once the shelves and door compartments are lled with food or
drinks, the top two doors might not align properly. There are three
C-type washers to adjust the doors. Follow the steps below to level
the doors.
1. Make sure the fridge is level.
2. If the top of the top two doors appears to be misaligned, lift the bottom
door slightly and insert a type C washer with a clip between the bottom of
the door and the middle hinge.
Before installing the appliance, carefully review the safety information (chapter 1).
3.1 INSTALLING THE APPLIANCE
Bekijk gratis de handleiding van Veripart VDND362DZ, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Veripart |
| Model | VDND362DZ |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 6797 MB |
