VAX Steam Glide CDHF-SGXA handleiding
Handleiding
Je bekijkt pagina 11 van 20
11
USING YOUR MACHINE
Hold the corner of the pad
down with your foot and lift
the machine to peel away.
IMPORTANT: When using on carpets, always make sure the microfibre pad is used and covers the floorhead entirely before
using the carpet glider. Only use the carpet glider when refreshing carpets.
Place foot onto the
floorhead and pull the
handle backwards to recline.
Move the machine slowly
backwards and forwards
across the carpet paying
particular attention to high
traffic areas.
To release the carpet glider,
place your foot on the clip
and push down. Lift the
machine to remove.
Turn the dial to ‘OFF’
position and allow the
machine to cool. The red
light will switch off.
Refreshing carpets
With the microfibre pad
attached, push the machine
into the front of the carpet
glider, then place the back of
the floorhead into the clip.
Place the microfibre pad on
the floor white side facing
up. Place the floorhead onto
the microfibre pad making
sure the microfibre pad
covers the entire floorhead.
Plug into the mains and
turn the dial to 'ON'.
The red light will illuminate.
The machine will be ready
after approximately 30
seconds. During this time
there will be no sound
whilst it is heating up.
Twist the steam control dial
to the desired setting. Steam
is activated automatically.
Bekijk gratis de handleiding van VAX Steam Glide CDHF-SGXA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VAX |
| Model | Steam Glide CDHF-SGXA |
| Categorie | Stoomreiniger |
| Taal | Nederlands |
| Grootte | 1821 MB |
