Varytec Event Par IP65 4in1 14x8W WDMX handleiding
Handleiding
Je bekijkt pagina 21 van 48
Push the lock of the battery holder towards the centre of the housing and pull out the battery
holder like a drawer. Insert the batteries. The battery is correct if the positive pole points to the
housing base of the remote control. Slide the battery holder back into the remote until it clicks
into place.
When shipping, the battery is already installed in the remote and protected against discharge
by a transparent plastic lm. Remove the plastic lm before initial use.
NOTICE!
Risk of re due to incorrect polarity!
Incorrectly inserted batteries may cause res and destroy the device and the bat‐
teries.
Observe the markings on the batteries and on the device.
Ensure that proper polarity is observed when inserting batteries.
NOTICE!
Possible damage due to leaking batteries!
Batteries can leak and cause permanent damage to the device.
Take the batteries out of the device if it is not going to be used for an extended
period of time.
Inserting the battery into the
remote control
Starting up
Event Par IP65 4in1 14x8W, Event Par IP65 4in1 14x8W WDMX
21
LED PAR
Bekijk gratis de handleiding van Varytec Event Par IP65 4in1 14x8W WDMX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Varytec |
| Model | Event Par IP65 4in1 14x8W WDMX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2921 MB |
