Valberg WD 10714 A 10/D W180C Handleiding (144 Pagina's)

Handleiding

24

EN

Dry fault

Fault phenomenon Recommended processing method

Dry fault

Washing machine does not

carry out dry process

• Check whether the dry program is set up.

• Check whether the water tap is unopened.

• Check whether the door is well closed.

• Check whether the dry clothes are excessive (refer to

the program table and check corresponding capacity

of the program), and take out part of the clothes to

dry again.

Dry is not sufﬁcient

• Check whether the dry clothes are excessive. If so,

it will cause unsatisfactory dry effects and folds in

clothes. Please divide the clothes in the drum into

two parts for drying separately.

• Check whether the clothes (such as thicker cotton,

etc.) that are not easy to dry are mixed with the

clothes that easy to dry (such as chemical ﬁber, etc.).

Please dry the clothes of different types separately

or dry them again.

Dry time is too long

• Check whether the drying clothes are excessive

(refer to the program table and check corresponding

capacity of the program), and take out part of the

clothes to dry again.

• Clothes are not fully dewatered (refer to the

treatment of bad dehydrated effect in the manual).

• More thicker clothes (denim, etc.).

Programme Instructions

1. The eco 40-60 programme is able to clean normally soiled cotton laundry declared to be

washable about 40°C to 60°C, together in the same cycle, and that this programme is

used to assess the compliance with the EU ecodesign legislation.

2. The power consumption of the off-mode is 0.49W,and the left-on mode is 0.49W.

3.

The most efﬁcient programmes in terms of energy consumption are generally those that

perform at lower temperatures and longer duration.

4.

Loading the household washing machine or the household washer-dryer up to the capacity

indicated by the manufacturer for the respective programmes will contribute to energy

and water savings.

5.

Correct use of detergent, softeners and other additives. Do not apply excessive detergent.

This may affect the washing results adversely.

6.

Periodic cleaning, including optimal frequency, and limescale prevention and procedure.

7. Noise and remaining moisture content are inﬂuenced by the spinning speed: the higher

the spinning speed in the spinning phase, the higher the noise and thrower the remainin

moisture content.

Product usage

B

Bekijk gratis de handleiding van Valberg WD 10714 A 10/D W180C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.