Handleiding
Je bekijkt pagina 9 van 64
8 FR
Informations pratiques
C
8 EN
Using the appliance
B
Gas connection
Gas connection and leak checks
The cooker must be connected to the gas supply by a qualied technician in compliance with
the applicable standards (in line with Article 10 of the Decree of 02-08-1977 and Building
Code regulations 61-1 which impose the presence of a control valve at the end of the pipe for
natural gas, with a pressure release trigger in compliance with the NF D 36-303 standard.
This control valve must allow for the gas supply to be shut off when the cooker is not in use).
Firstly, check the type of gas installed on the cooker. This information is indicated on a label
at the back of the cooker. You'll nd information regarding the types of gas and injectors in the
technical specications table. Make sure that the in-ow gas pressure is compliant with the
values specied in the technical specications table in order to guarantee optimal efciency
and minimum gas consumption. If the pressure of the gas used is not the same as these values
or variables, you'll need to add a pressure regulator to the in-ow pipe. We advise that you
contact the after-sales service in order to take these measurements and apply adjustments.
Butane (G30) - propane (G31) gas connection
The technician must rst check the gas setting of your cooker. If it has a natural gas supply,
they will need to change the injectors (see below), so that it can be used with butane gas.
The installation can be carried out either with a butane/propane specic gas hose sold with
2 clamps, or with a hose with a mechanical tip with mounted ttings.
If you would like to use a hose with a mechanical tip:
• use the tting supplied with the GN spare parts;
• ensure that the hose you are using complies with NFD 36112 or NFD 36125 standards:
• always use a gasket between the tting and the gas inlet.
If you are tting a butane/propane hose with a clamp, the butane gas connector with the
gasket must be tted to the cooker, the hose must be pushed all the way onto this connector
and a clamp must be tted, tightening it properly but not cutting the hose. Do the same on
the regulator side (see Fig. 7).
The maximum length permitted is 1.50 m.
(TFEM)
Adaptateur
Tuyau
de gaz
Joint
Joint
Mécanique
(TFEM)
Tuyau de gaz
Tuyau
de gaz
Tuyau
Raccord
(TFEM)
Tuyau de gaz
(TFEM)
Avec col
G1/2
FR
Adaptateur
Tuyau
de gaz
Joint
R1/2
BE
Mécanique
Tuyau de gaz
Mécanique
Tuyau de gaz
Tuyau de gaz
Avec col
Adaptateur
Tuyau
de gaz
JointJoint
Tuyau
de gaz
Tuyau
Raccord
G1/2
ES
Gas
hose
EN
Seal
Hose
connector
Gas hose
with clamps
Gas hose
Seal
Adapter
Ad Mecanic
gas hose
apter
Bekijk gratis de handleiding van Valberg MC 60 31MC S 701T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | MC 60 31MC S 701T |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5178 MB |
