Valberg FL5 handleiding
Handleiding
Je bekijkt pagina 11 van 70
10
EN
Use the Floorwasher
Fill the clean water cup
NOTE: We recommend that when you use the Floorwasher for the first time,
connect the Floorwasher to the power supply and keep the main body upright.
Then, fill up the clean water cup as described below. This will allow you to easily
determine the appropriate amount of water needed.
Before using the Floorwasher, fill the clean water cup with tap water (do not exceed the MAX
line marked on the cup).
NOTE: You can fill the cup with warm water; however, do not use water with
temperature over 60 degrees.
While pressing the clean water cup release button downward, pull to remove the cup.
Open the lid and fill the cup with tap water. Do not allow water to exceed the MAX
line marked on the cup overflow the cup with water.
NOTE: For deep cleaning, replace 16ml of tap water with neutral floor
liquid detergent (to be purchased separately).
Close the lid and make sure the cup is closed tight and no leakage.
Place the clean water cup back to the main body, and then push the cup in until it
clicks into place.
Power on the Floorwasher
1. Press the On/Off button on the handle to power on the Floorwasher.
2. Tilt the Floorwasher backward to start cleaning.
NOTE:
•
When standing upright, the Floorwasher will be powered off even if you press
the On/Off button.
• Do not tilt the Floorwasher over 150 degrees. Doing so might result in water
leakage from the water cups.
<150º
Product usage
B
Bekijk gratis de handleiding van Valberg FL5, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | FL5 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 5361 MB |
