Handleiding
Je bekijkt pagina 14 van 148
12
EN
Product usage
B
Moving and transport after installation
•
After every drying cycle, a small amount of condensed water will remain in the dryer.
Switch on the dryer and choose one of the programmes, then let the appliance operate
for approximately half a minute. This will pump out the remaining water and prevent
damage to the dryer during transport.
• If the dryer cannot be transported in the upright position, tilt it to the left side.
• Pack all the packaging material (plastic bags, other plastic parts etc.).
After transport, the dryer should be left to stand still for at least two hours
before it is connected to the power mains. The appliance should be installed
and connected by a trained technician.
NOTE:
•
If the appliance was not transported in compliance with the instructions, the
dryer should be left to stand still at least 24 hours before it is reconnected
to the power mains.
• Failure to do so may result in a heat pump failure which shall not be covered
by the warranty.
• Be careful not to damage the cooling system (see chapter “Installation and
connection / Dryer placement”).
Carefully read the instructions for use before connecting the dryer. Repair or
any warranty claim resulting from incorrect connection or use of the dryer shall
not be covered by the warranty.
Before using the appliance for the first time
•
Make sure the dryer is disconnected from the power mains; then, open the door by pulling
the left side of the door towards you (figures 1 and 2).
• Before using the dryer for the first time, clean the dryer drum using a soft damp cotton
cloth and water (figure 3).
Bekijk gratis de handleiding van Valberg DHP 9 D W180C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | DHP 9 D W180C |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 12211 MB |
