Valberg 14S40 B DXAD929C V2 handleiding
Handleiding
Je bekijkt pagina 12 van 164
10
EN
How to connect the safety supply hose
1.
Pull the safety supply hoses out from storage compartment located at rear of dishwasher.
2. Tighten the screws of the safety supply hose to the faucet with thread 3/4 inch.
3. Turn the water fully on before starting the dishwasher.
How to disconnect the safety supply hose
1. Turn off the water.
2. Unscrew the safety supply hose from the faucet.
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the
sink, making sure to avoid bending or crimping it. The height of drain pipe must be less than
1000mm. The free end of the hose must not be immersed in water to avoid the back flow of it.
WARNING!
Please securely fix the drain hose in either position A or position B.
Back of dishwasher
Mains Cable
Drain Pipe
Water Inlet
Counter
Drain hose
Drain Pipe
How to drain excess water from hoses
If the connection to the drain pipe is positioned higher than 1000mm, excess water may
remain in the drain hose. It will be necessary to drain excess water from the hose into a bowl
or suitable container that is held outside and lower than the sink.
Water outlet
•
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
• Ensure that the water drain hose is not kinked or squashed.
Product usage
B
Bekijk gratis de handleiding van Valberg 14S40 B DXAD929C V2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | 14S40 B DXAD929C V2 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 14958 MB |
