Vaddio ZoomSHOT 20 SE AVBMP handleiding
Handleiding
Je bekijkt pagina 42 van 53
Troubleshooting
Use this information to determine whether it's time to call Vaddio Technical Support.
Check the status light first
When the camera doesn't behave as you expect, check the status light before you do anything else.
n
Blue: Normal operation (blinks once when the camera receives a command from the remote)
n
Red: On-air tally (signal provided by external device)
n
Purple: Booting, restoring factory defaults, or updating firmware
Check the cables next
If the equipment behaves in a way that suggests even a remote possibility of a bad cable, please try a
known good cable with the same pin-out.
Cables can be defective, whether they are purchased from a vendor or made at the installation site.
Crimping tools can crimp unevenly, contacts can break internally, and individual conductors in the cable
can break inside the jacketing material. Any of these can result in a cable that passes a continuity check
but does not work reliably, or does not pass enough power to the connected device.
(The author would like to confess having made a certain number of almost-good cables. It happens.)
Power and control
What is it doing? Possible causes Check and correct
Nothing. The status light is
off, there is no video, and
the camera does not
respond to the remote.
The host device does not have
power.
Be sure the host device is connected
to the right power supply.
Verify that the power supply is
connected to a wall outlet that can
power other items such as a phone
charger.
The camera is not connected
correctly.
Check the way the camera is
connected to the host device.
A camera cable is bad. Connect the camera with known good
cables.
The camera or Quick-Connect
device is bad.
Contact Vaddio technical support.
The camera loses all its
settings when power is
cycled.
All the DIP switches are in the
DOWN position.
Set the DIP switches to their proper
positions. Default is all UP. See
Camera switch settings for more
information.
The camera's status light is
on, but it does not respond
to the remote.
The remote and the camera are
not using the same IR channel.
Press the Camera Select 1 button on
the remote. Try the other Camera
Select buttons if necessary.
The remote's batteries are dead. Put new batteries in the remote.
39
Complete Manual for the ZoomSHOT 20 SE Fixed Camera
Bekijk gratis de handleiding van Vaddio ZoomSHOT 20 SE AVBMP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vaddio |
| Model | ZoomSHOT 20 SE AVBMP |
| Categorie | Bewakingscamera |
| Taal | Nederlands |
| Grootte | 8455 MB |
